HP 24SII manual

If using an IBM PC or compatible to configure the Model 24SII DES, first make a copy of the BayTech supplied support software disk and store the original in a safe place. (Refer to your DOS manual for copy instructions). You will be using the TERM program created by running the INSTALL program (see Section 4.2) to change the default configuration of the Model 24SII DES. Any terminal emulation program supplied by another manufacturer may also be used. Make sure your PC is connected to Port 1 of Module 1 with the appropriate

1.From the￿￿￿BAYTECH subdirectory prompt enter: a:\term

The program will respond with an identification block

and￿￿￿￿then￿￿￿!￿"￿a￿￿￿￿￿￿￿￿￿configuration!￿￿￿￿# ￿￿￿￿￿($menu￿%!￿￿for￿%!￿￿the￿￿￿￿￿￿￿￿￿￿￿PC&!￿￿￿COM&￿&￿)￿port&%￿.￿￿￿￿'￿serial cable. Use the following procedure:

You are now in the terminal emulation mode with full duplex communication. Any characters you type from the keyboard will be transmitted out of the PC COM port to the Model 24SII DES. They will not appear on the CRT screen. Any characters received from the Model 24SII DES by the PC COM port will be displayed on the CRT screen.

2.	Ensure the displayed PC Configuration is correct. If not,
	enter ALT-C to change. For example, if you have your
	serial cable physically connected to COM2 on your PC,	￿￿
	first type ALT-C followed by the up arrow key and then
	ENTER to have the TERM program switch to COM2.