HP 24SII manual

&￿￿￿ ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

OPTION ACCESSIBILITY: Through Port 1 of Module 1 only.

By responding to the Enter request: message at the end of the main configuration menu (see Section 8.1) with "9" for any serial module or "8" for the M24SII-V02 high speed parallel module (Program I.D. Page Message), you may program the content of this identifying message.

The Model 24SII DES will respond with:

Enter Request :9

I.D. Page Message is :

This Print Job is from :

Enter C to change, or ENTER for no change :

If you desire to make a change, enter "C". The Model 24SII DES will respond with:

Enter I.D Page Message (Max. 40 characters)

Control-C to terminate or no change :

Enter the new message, followed by Control-C. Note that the message will print on paper exactly as it is placed on the CRT screen. The message may appear on one line or several lines. If several lines are desired, each line must be ended by Enter and Line Feed (^J).

For example, if you entered THIS IS THE NEW MESSAGE, the Model 24SII DES will respond with:

I.D. Page Message is :THIS IS THE NEW MESSAGE

Enter C to change, or ENTER for no change :

If no change in the message is desired, strike the Enter key, and the current message will be retained. The Model 24SII DES will save the new I.D. Page Message permanently in non-volatile memory and will ￿￿subsequently power-up with that message in effect.

The Model 24SII DES will now return to the main configuration menu (see Section 8.1).