&￿￿# ￿￿￿￿￿￿!￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

OPTION ACCESSIBILITY: Through any serial computer port.

By responding to the Enter Request: message at the end of the main configuration menu (see Section 8.1) with "8" for any serial module or "7" for the M24SII-V02 high speed parallel module (Enable/Disable Form Feed Mode), you may enable form feed and select when form feed occurs, or disable form feed.

The Model 24SII DES will respond with:

Enter Request :8

-------------------------------------------

Port

Logical Name

Form feed

I.D.

(Computer)

Begin End

Page

-------------------------------------------

1

Device A

Off Off Off

3

Device

C

Off

Off

Off

4

Device

D

Off

Off

Off

-------------------------------------------

Enter Port Number (ENTER=Exit) :

Enter the number of the port for which you wish to set the Form Feed Mode and then strike the Enter key. For example, if you entered "3" for Port 3 and Enter, the Model 24SII DES will respond with:

Form Feed at the Beginning of Printing is (OFF)

Enter 1 for ON, 2 for OFF, ENTER for no change :

You should then enter "1" if you wish to enable form feed at the beginning of printing, "2" if you wish to disable form feed at the beginning of printing, or strike the Enter key if no change from the present condition is required. For example, if you entered "1", the Model 24SII DES will respond with:

Form Feed at the Beginning of Printing is (ON)

Enter 1 for ON, 2 for OFF, ENTER for no change :

￿￿