Empire Comfort Systems VFSUR30-2, VFSUR24-2, VFSUR18-2 VFSUR-18,24,30-2 Lighting Instructions

Page 16

VFSUR-(18,24,30)-2 LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

Warning: If you do not follow these instructions exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electrical switch; Do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above on this page.

2.Open bottom louver assembly (if applicable).

3. Set REMOTE/OFF/ON switch to "OFF".

4. Turn off all electric power to the appliance (if applicable).

5. Push in gas control knob slightly

 

GAS CONTROL KNOB

and turn clockwise

to

SHOWN IN "OFF" POSITION.

 

 

"OFF".

 

 

REMOTE

NOTE: Knob cannot be turned from "PILOT"

OFF

to "OFF" unless knob is pushed in slightly.

ON

Do not force.

8. Turn gas control knob counterclockwise

to "PILOT".

9. Push in control knob all the way and hold in. Repeatedly push

the Piezo Ignitor Button until the pilot is lit. Continue to hold

the control knob in for about one (1) minute after the pilot is

lit. Release knob, and it will pop back up. Pilot should remain

lit. If it goes out, repeat steps 5 through 9.

• If knob does not pop up when released, STOP and IM-

MEDIATELY call a qualified service technician or gas

supplier.

• If the pilot will not stay lit after several tries, turn the gas

control knob to "OFF" and call your service technician

or gas supplier.

6.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above. If you do not smell gas, go to the next step.

PILOT

THERMOPILE

ELECTRODE

THERMOCOUPLE (LPG)

THERMOCOUPLE (NATURAL)

10.

Turn gas control knob counterclockwise

to "ON".

11. Set REMOTE/OFF/ON switch to desired setting.

 

12.

Turn on all electric power to the appliance (if applicable).

13.

Close bottom louver assembly (if applicable).

 

7.Find pilot - Follow metal tube from

gas control. The pilot is located next to the burner, near the right side.

TO TURN OFF GAS TO APPLIANCE

1.Open bottom louver assembly (if applicable).

2.Set REMOTE/OFF/ON switch to OFF.

3.Turn off all electric power to the appliance if service is to be performed (if applicable).

4.Push in gas control knob slightly and turn clockwise to "OFF". Do not force.

5.Close bottom louver assembly (if applicable).

Page 16

25741-0-0309

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Empire Table of Contents Carton Contents Hardware PackageImportant Safety Information Carbon Monoxide Poisoning MAY Lead to DeathSafety Information for Users of LP-GAS LP-GAS Warning OdorWell Head Gas Installations New InstallationIntroduction Before you get started General InformationMake sure you have received all parts Important Safety Information Requirements for CanadaWater Vapor a BY-PRODUCT of Unvented Room Heaters Unusually Tight ConstructionInstalling as a Vented Appliance ClearancesGlass Doors Mantel Clearances Without Hood FigureMantel Clearances with Hood Figure Floor Clearance FigureCombustible Material Fireplace PreparationBefore Fully Installing the Appliance Installing AS a Vented ApplianceInstalling Damper Clamp Figure Installing a New Main Gas Cock Pressure Testing of the Gas Supply SystemGAS Supply Recommended Gas Pipe DiameterOperation INSTRUCTIONS/FLAME Appearance Placement of Glowing Embers and Lava RockPlacing Lava Rock in Front of Burner on Fireplace Floor VFSUR-18,24,30-2 Lighting Instructions What to do if YOU Smell GASBurner Instructions Lighting the multisided burnerCleaning and Servicing Pilot Flame CharacteristicsTurn OFF Heater and Allow to Cool Before Cleaning Wiring Gas odor even when control knob is in OFF position Heater produces a whistling noise when main burner is litAppliance produces unwanted odors Appliance shuts off during use. Pilot stays onHOW to Order Repair Parts Parts Not Under WarrantyWarranty Parts Master Parts Distributor ListIndex Part Number Description Parts ListVFSUR18N,P VFSUR24N,P VFSUR30N,P Parts View Comfort Systems

VFSUR18-2, VFSUR30-2, VFSUR24-2 specifications

Empire Comfort Systems is renowned for its innovative heating solutions, and the VFSUR series exemplifies their commitment to quality and performance. The VFSUR24-2, VFSUR30-2, and VFSUR18-2 models are direct vent, free-standing gas stoves that combine timeless design with modern technology, making them ideal for both heating and aesthetic enhancement in any living space.

One of the standout features of the VFSUR series is their impressive heating capacity. The VFSUR18-2 offers a maximum output of 18,000 BTUs, the VFSUR24-2 delivers 24,000 BTUs, and the VFSUR30-2 tops out at 30,000 BTUs. This range allows homeowners to choose a model that best fits their space and heating needs, effectively warming areas from smaller rooms to larger open living areas.

Another significant characteristic of the VFSUR models is their direct vent technology, which allows for safe and efficient ventilation. This system draws air from outside for combustion while expelling exhaust gases outside as well, creating a sealed combustion environment that enhances safety and minimizes heat loss. This technology also ensures that indoor air quality is maintained, making these stoves an excellent choice for energy-conscious homeowners.

The VFSUR series features a stylish design that incorporates a traditional look with modern elements. With various finish options and decorative doors, these stoves can complement any home décor. The large viewing window provides a cozy ambiance, allowing users to enjoy the beauty of the flames while the stove efficiently heats the space.

Additionally, the VFSUR models are equipped with an advanced millivolt system that allows for reliable operation even during power outages. This feature ensures that users will have continuous warmth regardless of external conditions. The models are also compatible with optional remote controls, providing convenience in adjusting settings from anywhere in the room.

In summary, Empire Comfort Systems VFSUR series – including the VFSUR24-2, VFSUR30-2, and VFSUR18-2 – represent a fusion of efficiency, safety, and style. With impressive BTU outputs, advanced direct vent technology, and aesthetic versatility, these gas stoves are perfect for anyone looking to enhance their home heating experience while enjoying the warmth and beauty of a traditional fireplace.
Top Page Image Contents