CLEARANCES (continued)
Mantel Clearances with Hood (Figure 5)
You must have
Heat resistant materials such as slate and marble must be at least 1/2" thick. Sheet metal should not be installed onto combustible material.
Example: A mantel may project from the wall a maximum of 2" at a minimum of
Floor Clearance (Figure 6)
If installing heater at floor level, the minimum distance to com- bustibles is “0” inches.
FIREPLACE OR
FIREBOX TOP
HEATER IN
FIREPLACE
OR FIREBOX
COMBUSTIBLE | COMBUSTIBLE |
MATERIAL | MATERIAL |
8” Mantel
6” Mantel
4” Mantel
2” Mantel
16.0” | 14.25” | ||||
| 15.0” |
| 13.5” | ||
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
HOOD
HEAT RESISTANT
MATERIAL 8”
WITH HOOD
8” Mantel
6” Mantel
4” Mantel
2” Mantel
| 14.25” |
| 16.0” | ||
|
|
|
|
| |
13.5” |
| 15.0” |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
HOOD
HEATER IN
FIREPLACE
OR FIREBOX
Figure 6
Figure 5
If your installation does not meet the above minimum clearances, you must proceed to one of the following steps:
•Operate the heater with the flue damper open. See page 12 for Installing as a Vented Appliance.
•Raise the mantel to the proper height.
•Remove the mantel.
Page 11 |