Empire Comfort Systems VFSUR30-2, VFSUR24-2, VFSUR18-2 General Information, Before you get started

Page 7

GENERAL INFORMATION

This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided.

Keep room area clear and free from combustible materials, gasoline and other flammable vapors and liquids.

Unvented gas heaters are a supplemental zone heater. They are not intended to be a primary heating appliance. Water vapor produced by an unvented heater can create moisture problems in a home when operated for extended periods of time.

During manufacturing, fabricating and shipping, various components of this appliance are treated with certain oils, films or bonding agents. These chemicals are not harmful but may produce annoying smoke and smells as they are burned off during the initial operation of the appliance; possibly causing headaches or eye or lung irritation. This is a normal and temporary occurrence.

The initial break-in operation should last 2-3 hours with the burner at the highest setting. Provide maximum ventilation by opening windows or doors to allow odors to dissipate. Any odors remaining after this initial break-in period will be slight and will disappear with continued use.

This appliance must not be used with glass doors in the closed position. This can lead to pilot outages and severe sooting outside the fireplace.

Do not use this room heater if any part has been under water. Immediately call a qualified service technician to inspect the room heater and replace any part of the control system and any gas control which has been under water.

Warning: This appliance is equipped for (natural or propane) gas. Field conversion is not permitted.

Before you get started

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts in good condition.

Make sure you have received all parts:

Check your packing list to verify that all listed parts have been received. You should have the following:

Gas log grate/burner assembly.

Three (3) masonry anchoring screws and three (3) 10 x 1/2" black sheet metal anchoring screws.

Plastic bag containing glowing embers (rockwool) for burner coverage.

Plastic bag containing lava rock.

Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions.

Wall switch or thermostat with wire.

Hand held remote control with ON/OFF switch or thermostat.

Handle the gas log burner assembly by the grate and legs only. Do not pick the unit up by the burner.

Gloves are recommended when handling logs to prevent skin irritation. Logs are fragile - Handle with care.

Qualified Installing Agency

Installation and replacement of gas piping, gas utilization equip- ment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation, or company that either in person or through a representative is engaged in and is responsible for (a) the installation, testing, or replacement of gas piping or (b) the connection, installation, testing, repair, or servicing of equipment; that is experienced in such work; that is familiar with all precau- tions required, and that has complied with all the requirements of the authority having jurisdiction.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

Sellers of unvented propane or natural gas-fired supplemental room heaters shall provide to each purchaser a copy of 527 CMR-30 upon sale of the unit.

In the State of Massachusetts, unvented propane and natural gas-fired space heaters shall be prohibited in bedrooms and bathrooms.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1* or International Fuel Gas Code.

*Available from the American National Standards Institute, Inc. 11 West 42nd St., New York, N.Y. 10018.

High Altitudes: For altitudes/elevation above 2,000 feet ratings should be reduced at the rate of 4 percent for each 1,000 feet above sea level. Contact the manufacturer.

25741-0-0309

Page 7

Image 7
Contents Empire Table of Contents Hardware Package Carton Contents Carbon Monoxide Poisoning MAY Lead to Death Important Safety InformationLP-GAS Warning Odor Safety Information for Users of LP-GASWell Head Gas Installations New InstallationIntroduction Before you get started General InformationMake sure you have received all parts Requirements for Canada Important Safety InformationUnusually Tight Construction Water Vapor a BY-PRODUCT of Unvented Room HeatersMantel Clearances Without Hood Figure Installing as a Vented ApplianceClearances Glass DoorsFloor Clearance Figure Mantel Clearances with Hood FigureFireplace Preparation Combustible MaterialBefore Fully Installing the Appliance Installing AS a Vented ApplianceInstalling Damper Clamp Figure Recommended Gas Pipe Diameter Installing a New Main Gas CockPressure Testing of the Gas Supply System GAS SupplyOperation INSTRUCTIONS/FLAME Appearance Placement of Glowing Embers and Lava RockPlacing Lava Rock in Front of Burner on Fireplace Floor What to do if YOU Smell GAS VFSUR-18,24,30-2 Lighting InstructionsLighting the multisided burner Burner InstructionsCleaning and Servicing Pilot Flame CharacteristicsTurn OFF Heater and Allow to Cool Before Cleaning Wiring Appliance shuts off during use. Pilot stays on Gas odor even when control knob is in OFF positionHeater produces a whistling noise when main burner is lit Appliance produces unwanted odorsMaster Parts Distributor List HOW to Order Repair PartsParts Not Under Warranty Warranty PartsIndex Part Number Description Parts ListVFSUR18N,P VFSUR24N,P VFSUR30N,P Parts View Comfort Systems