STEP 5 – Program the Communications Module
You must use the 7720P Programming tool to program the
When using the 7720P Programming tool, the values given below are for most installations. Press the [#] key to accept the displayed default value (xxx) or enter the new value and press the [#] key for the next prompt. Use the [Space] key to scroll through a list of options.
1.
(no display)
Connect the 7720P.
2.
7720P PROGRAMMER
Press [#].
3.Strt Prog Mode? Y/N
4.Program Device? Y/N
5.Com Path Choice (IP&GSM)
6.Primary City ID (??)
7.Primary CS ID (??)
| 8. |
| Primary Sub ID (????) |
|
|
|
|
| |
|
|
|
|
|
9.Use DHCP? Y/N (Y)
10.NIC IP Address: 255.255.255.255
11.Subnet Mask: 255.255.255.255
12.Gateway IP Address: 255.255.255.255
13.DNS Serv IP Addr: 255.255.255.255
14.Review? Y/N
15.Create Password? Y/N
16.Exit Prog Mode? Y/N
17.DONE
Press [Shift] then [Y], then [#].
Press [Shift] then [Y], then [#].
Press [Space] to scroll choices; IP&GSM, IP, or GSM. At choice, press [#].
Enter number
Enter number
Enter number
Note: If a Com Path Choice of IP&GSM or IP was selected, prompt 9 will appear.
If your router is configured for DHCP, press [Shift] then [Y], then press [#].
Note: If DHCP is not selected (your router is set for a static IP), prompts 10 through 13 will appear.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Enter choice, then press [#]. Follow the prompts.
Press [Shift] then [Y], then press [#].
Note: If an error in programming occurs, set the factory defaults (see next topic) and reprogram the
– 6 –