Bosch Appliances D7024 manual Fire Safety, Smoke Detector Layout, General Considerations

= Smoke Detector

Basement

D7024

Fire Safety

9.0Fire Safety

No fire detection device or system should be considered 100% foolproof.

This fire alarm system can provide early warning of a developing fire. Such a system, however, does not ensure protection against property damage or loss of life resulting from a fire. Any fire alarm system may fail to warn for any number of reasons (e.g. smoke not reaching a detector that is behind a closed door).

This system must be regularly tested (when installed, when modified and at least annually thereafter) to ensure continued performance.

When considering detectors for residential applications, refer to NFPA Standard 72, “The National Fire Alarm Code.” This standard is available at a nominal cost from: The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.

9.1Smoke Detector Layout

9.1.1General Considerations

Proper location of detection devices is one of the most critical factors in a fire alarm system.

Smoke detectors should not be installed in “dead air” spaces or close to ventilating or air conditioning outlets because smoke may be circulated away from the detector. Locations near air inlets should be favored.

Avoid areas subject to normal smoke concentrations such as kitchens, garages, or near fireplaces.

Do not install smoke detectors where normal area temperatures are above 100°F (38°C) or below 32°F (0°C).

Areas of high humidity and dust concentrations should be avoided.

The edge of ceiling mounted detectors should be no closer than 4 inches (10 cm) from any wall.

Place the top edge of wall mounted detectors between 4 and 12 inches (10 and 30 cm) from the ceiling.

For exact mounting information, refer to the instructions provided with the smoke detectors.

9.1.2If Installed in Family Residences

Providing a Fire Warning System: Most fire deaths occur in the home, especially during sleeping hours. The minimum level of protection requires smoke detectors to be installed outside of each separate sleeping area and on each additional story of the dwelling.

For added early warning protection, it is recommended that detectors be installed in all separated areas including the basement, bedrooms, dining room, utility room, furnace room, and hallways.

Bedroom	Hall	Bedroom
	*

Rec Room

Dining Room

Kitchen Bedroom

Living	*	Dining
Room		Room

*

Living Room *

*= Smoke Detector

Bedroom

*

A*smoke detector should be located on each story including basements, but excluding crawl spaces and unfinished attics.

Bedroom

Locate smoke detectors between sleeping areas and family living areas.

Figure 15: Smoke Detector Location in Residential Settings

	D7024 Operation and Installation Guide
41740F	Page 82	© 2005 Bosch Security Systems