Hearth and Home Technologies FB-ZC-S owner manual Lighting Appliance, Standing Pilot Ignition

Page 27

B. Lighting Appliance

Standing Pilot Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS

1.Turn off all electric power to the appliance.

2.Push in gas control knob slightly and turn clockwise to “OFF”.

A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these in- structions exactly.

B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to re- pair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

NOTE: Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.

3.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the Safety Informa- tion located on the left side of this label. If you don’t smell gas, go to next step.

4.Find the pilot. The pilot is inside combustion chamber next to the main burner.

5.Turn knob on gas control counter clockwise

to “PILOT”.

6. Push in control knob all the way and hold in. Im-

mediately depress red or black piezo button. It may

require several depressions of the red or black

piezo button until PILOT lights. If PILOT light does

WARNING: CAUTION:

not light after 10 seconds, return to step 3. Continue to

hold the control knob in for about one minute after the

pilot is lit. Release knob and it will pop back out. Pilot

should remain lit. If it goes out, repeat steps 3 through 6.

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, al- teration, service or maintenance can cause injury or property damage. Re- fer to the owner’s information manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause can- cer, birth defects, or other reproduc- tive harm.

Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.

Hot while in operation. Do not touch. Keep children, clothing, furniture, gaso- line and other liquids having flammable vapors away.

Do not operate the appliance with panel(s) removed, cracked or broken. Replacement of the panel(s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and propane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the alternate fuel.

Also Certified for Installation in a Bedroom or a Bedsitting Room.

For assistance or additional informa- tion, consult a qualified installer, ser- vice agency or the gas supplier.

• If knob does not pop up when released, stop and im-

 

mediately call your service technician or gas supplier.

•

If the pilot will not stay lit after several tries, turn

 

the gas control knob to “OFF” and call your service

 

technician or gas supplier.

7.

Turn gas control knob counterclockwise to

“ON”.

8.To light Burner, flip the on/off switch to the “ON” position, and close access grille.

9.Turn on all electric power to the appliance.

TO TURN OFF GAS TO APPLIANCE

1. Turn off all electric power to the appliance if service is to be performed.

2.

Open control access panel.

3.

Move switch to “OFF” position.

4.

Push in gas control knob slightly and turn clock-

 

wise

to OFF”. Do not force.

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

5.

Close control access panel.

 

464-903G

Heat & Glo • FB-ZC-S • 2019-910 Rev. G • 11/08

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents What to do if you smell gas ModelHomeowner Reference Information CongratulationsTable of Contents Listing and Code Approvals Tools and Supplies Needed Design and Installation ConsiderationsGetting Started Inspect Appliance and ComponentsInspect Firebox Minimum Fireplace Opening Fireplace Size RequirementsClearances to Mantels or other Combustibles above Appliance ClearancesVent Termination Minimum Clearances Termination LocationsMeasuring Standards Vent Information and DiagramsVent Table Key Horizontal VentingInstallation Preparation Installing Vent Pipe and Appliance Connecting Vent PipeVenting Components Class a Wood Pipe Inlet AIR Vent Pipe Stainless Steel Placing, Securing and Leveling the Appliance Damper Flashing Kit Optional Installing Adaptor and Termination CapMasonry Factory Built Wood BurningGas Information Fuel Conversions Gas ConnectionGas Pressures High Altitude Installations Appliance Requirements Wiring the ApplianceON/OFF Switch Electrical InformationJunction Box Installation Installation for Fan OptionalOptional Accessories Fan Wiring Diagram Mantel Projections FinishingEmber Placement Appliance SetupClean the Appliance AccessoriesPositioning the Logs Log Set Assembly LOGS-FB-ZCGroove Replacing Glass Assembly Glass AssemblyAir Shutter Setting Removing Glass AssemblyOperating Instructions Before Lighting ApplianceBefore operating this appliance have a qualified technician Standing Pilot Ignition Lighting ApplianceInitial Break-in Procedure Check Pilot Flame AppearanceAfter Appliance is Lit Issue Solutions Frequently Asked QuestionsTroubleshooting Symptom Possible Causes Corrective ActionStanding Pilot Ignition System Symptom Possible Cause Corrective Action TroubleshootingMaintaining and Servicing Appliance Maintenance TasksDoors, Surrounds Inspect Maintenance TasksReference Materials Appliance Dimension DiagramDirect Vent Flex Liner Kits Vent Kits ComponentsLog Set Assembly Service PartsPart number list on following Service Parts List StockedAt Depot Service Parts Valve AssemblyCONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Contact Information

FB-ZC-S specifications

Hearth and Home Technologies has consistently been at the forefront of innovative heating solutions, and the FB-ZC-S is a prime example of their dedication to quality and performance. This gas fireplace has been designed not only for aesthetic appeal but also for optimal functionality, making it an excellent choice for modern homes.

One of the standout features of the FB-ZC-S is its impressive heating efficiency. Utilizing advanced gas technology, this fireplace ensures a high rate of heat output while maintaining low emissions. Homeowners will appreciate the efficient use of fuel, which translates into cost savings on energy bills. The FB-ZC-S is capable of producing a significant amount of heat, making it suitable for larger spaces.

The design of the FB-ZC-S is another highlight, featuring a sleek, contemporary look that fits well with a variety of interior styles. Its clean lines and minimalist approach allow it to blend seamlessly into any living area while serving as a stunning focal point. The unit comes with a variety of customizable options, including different front styles, decorative media, and trim finishes, enabling homeowners to personalize their fireplace according to their tastes.

Hearth and Home Technologies has equipped the FB-ZC-S with state-of-the-art technologies, including an easy-to-use control system. The intuitive interface allows users to adjust the flame height and heat output with ease, providing the ultimate comfort at their fingertips. Additionally, the fireplace can be integrated with smart home systems, enabling users to control their heating from anywhere, whether via smartphone or voice commands.

Further enhancing its appeal, the FB-ZC-S features a direct vent system that offers safe and efficient operation. This system allows for the expulsion of combustion gases outside the home while drawing in outside air for combustion, thus maintaining indoor air quality. Safety is paramount, and the FB-ZC-S is built with multiple safety features, including automatic shut-off systems and high-temperature safety locks.

In summary, the Hearth and Home Technologies FB-ZC-S is a state-of-the-art gas fireplace that blends modern design with advanced heating technology. Its impressive efficiency, customizable options, user-friendly controls, and safety features make it a standout choice for homeowners looking to enhance their living space with effective and stylish warmth. Whether for cozy family gatherings or serene evenings at home, the FB-ZC-S is designed to provide both comfort and charm.
Top Page Image Contents