Hearth and Home Technologies EM-415H Listing and Code Approvals, Appliance Certification

Page 4

1

Listing and Code Approvals

 

 

 

 

 

 

A. Appliance Certification

 

 

WARNING

 

This fireplace system has been tested and listed in accor-

 

dance with UL 127 and ULC-S610standards by Underwrit-

 

 

Improper installation, adjustment, alteration, service

 

ers Laboratories Inc. for installation and operation in the

 

or maintenance can cause injury or property damage.

 

United States and Canada.

Refer to the owner’s information manual provided with

 

This fireplace has been tested and listed for use with the op-

this fireplace. For assistance or additional information

 

consult a qualified installer, service agency or your

 

tional components specified in this manual. These optional

 

dealer.

 

components may be purchased separately and installed at

 

 

 

a later date. Installation of an outside air kit will require sig-

 

 

nificant reconstruction and is best if installed at the time of

 

 

fireplace installation.

 

 

Not intended for use as a primary heat source.

 

Heat & Glo is a registered trademark of Hearth & Home

 

This fireplace is tested and approved as a decorative fire-

 

Technologies Inc.

 

 

 

 

place. It should not be factored as a primary heat source

 

 

 

 

in residential heating calculations.

 

 

 

 

 

 

 

WARNING

 

 

 

 

Fire Risk

 

 

 

Do not install or operate damaged fireplace.

 

 

 

Do not modify fireplace.

 

 

 

• Installation other than as instructed by Hearth & Home

 

 

 

Technologies Inc. is strictly prohibited.

 

 

 

Do not operate the fireplace without fully assembling

 

 

 

all components.

 

 

 

Do not overfire.

 

 

 

Do not install an unvented gas log set. This fireplace

 

 

 

has not been tested for use with unvented gas log

 

 

 

sets.

 

 

 

• Installation and/or use of any component part not

 

 

 

approved by Hearth & Home Technologies.

 

 

 

Hearth & Home Technologies disclaims any responsibility

 

 

 

for, and the warranty and agency listing will be voided by

 

 

 

the above actions.

 

 

 

 

 

 

 

 

4

Heat & Glo • EM-415/EM-415H • 31317 Rev Q • 10/06

Image 4
Contents Models EM-415 EM-415H Woodburning Fireplace Fire RiskGrate Listing Label Information/LocationNumber Table of Contents Appliance Certification Listing and Code ApprovalsNot intended for use as a primary heat source Design and Installation Considerations Getting StartedNegative Pressure Asphyxiation RiskMarginal Location Typical Fireplace System Typical Fireplace SystemInspect Fireplace and Components Tools and Supplies NeededFire Risk Explosion Risk Framing and Clearances Selecting Fireplace LocationClearances Clearances to Combustible MaterialsSidewalls/Surrounds Frame the Fireplace¨E. Construct the Chase Chimney RequirementsInstallation of Fireplace Install the Outside Air KitFire Risk Sharp Edges Asphyxiation Risk Risk of Smoke SpillageFt min. from top of uppermost chimney section to air inlet Secure the Fireplace Position the FireplacePlace the Protective Metal Hearth Strips Level the FireplaceChimney Assembly Height of Chimney Components Using Offsets/Returns Degree SL306 SL312 SL318 SL324 SL336 SL348Install the Ceiling Firestops Assemble the Chimney SectionsDouble-check the Chimney Assembly Install the Attic Insulation ShieldSecure the Chimney Complete the Enclosure Chimney TerminationInstall the Chimney Air Kit required in Canada Install the Termination CapChase Top Installing an ST375 Square Termination Cap Accessories Junction Box InstallationGas Log/Lighter Provisions Gas Code, Ansi Z223.1Installation of Fan Shock RiskFinishing Hearth ExtensionFinishing Material MantelGlass Doors Combustible MaterialOperating Instructions General InformationOutside Air Clear Space Near the FireplaceFlue Damper FirescreenGrate Wood FuelFirewood MoistureStarting a Fire Troubleshooting Understanding Vent ProblemsDiagnostics and Problem Solving Diagnostic QuestionsSolutions Can’t get a good fire going. What am I doing wrong?fireplace burns the wood too fast. What can I do? Maintenance and Servicing the Fireplace Chimney Inspection/CleaningDisposal of Ashes Firebox RefractoryMaintenance Task List When cleaning glass doorClean Chimney FireFireplace Dimensions Reference Materials¨ B. Fireplace Components Catalog # DescriptionChimney Components Catalog #14-1/2 1829 mm 10-7/8 276 mm 406 mm 508 mm Minimum Base Dimensions 28 X 28 with 32 X 32 with 23 X Minimum Base Dimensions 26.5 X 28 with 34 X 34 withTR442 TR442 / 444 TV 20 xService Parts EM-415 SeriesDescription of Part EM-415 EM-415H Qty Herringbone Brick Refractory option available week 03/04This page intentionally left blank Warranty For Heat & GLO Fireplaces Limited WarrantyContact Information