Hearth and Home Technologies HST-48D Check Firebox Refractory, Inspect Grate, Glass Cleaning

Page 12

C. Check Firebox Refractory

Frequency: After each ash removal

By: Homeowner

WARNING! Risk of Fire! Inspect fireplace refractory. Crumbling, deteriorated refractory can allow overheating of surrounding materials.

Expansion and contraction will cause minor cracking of the refractory. This is normal. The refractory will require periodic replacement depending on use.

The panels should be replaced if

Cracks exceed ¼ inch (6 mm) in width,

Metal is exposed behind the refractory,

Large pieces of refractory fall out.

D. Inspect Grate

Frequency: After each ash removal

By: Homeowner

Inspect grate for:

Warping or sagging 1-1/2 in. (38 mm) or more

Broken welds

Burn-through of grate bars

For safe operation, replace only with an approved grate from Hearth & Homes Technologies Inc.

E. Glass Cleaning

Frequency: As desired

By: Homeowner

CAUTION! Handle glass assembly with care. Glass is breakable.

Avoid striking, scratching or slamming glass

Avoid abrasive cleaners

DO NOT clean glass while it is hot

Clean glass with a non-abrasive commercially available cleaner or ashes:

Light deposits

-Use household glass cleaner

Heavy deposits

-Use wood ash on damp cloth or,

-Use commercial fireplace glass cleaner (consult with your dealer)

12

Heat & Glo • HST-48D US-CAN4012-040 • Rev F • 11/08

Image 12
Contents Wood Burning Fireplace OperationHot screen/mesh and glass doors will cause burns Fire RiskListing Label Information/Location GrateNumber Table of Contents Installer GuideUser Guide Warranty Hearth & Home Technologies Limited Warranty CONDITIONS, Exclusions & Limitation of LiabilityHeat & Glo HST-48D US-CAN 4012-040 Rev F 11/08 Listing and Code Approvals Appliance CertificationNon-Combustible Materials Combustible MaterialsOperating Instructions Your FireplaceHot glass will cause burns Seasoned Wood Starting a FireGrate Firescreen Glass Doors Vented Gas Log Sets & Gas Log Lighters Optional Components Clear SpaceWood Fuel Hardwood vs SoftwoodMaintainance and Service Chimney Inspection/CleaningDisposal of Ashes Glass Cleaning Check Firebox RefractoryInspect Grate Frequency As desiredTroubleshooting Guide Start Fire Problems Possible Cause SolutionGetting Started Typical Fireplace SystemDesign and Installation Considerations DraftNegative Pressure Locating Fireplace & Chimney Frequently open doors Central heat outlets or returnsTools and Supplies Needed Fireplace System RequirementsInspect Fireplace and Components Framing & Clearances Select Fireplace Location1676 mm Hearth Clearances Clearances to Combustible MaterialsSidewalls/Surrounds Frame the FireplaceInstallation of Fireplace Things to ConsiderPosition the Fireplace Place Protective Metal Hearth StripsFt min. from top of uppermost chimney section to air inlet YESInstall Outside Air Kit Hood Wire TiesOutside Air Chimney Assembly Maintain minimum height of chimney above roofChimney Requirements C,fUsing Offsets/Returns ExampleInstall Chimney Air Kit Assemble Chimney SectionsInstall Ceiling Firestops Installing the Ceiling FirestopInstall Attic Insulation Shield 330 mmComplete Installation Install FlashingCut out Hole in Roof Chimney Termination Requirements Flat RoofsChase Installations Construct the ChaseInstall Fireplace & Chimney Install Chase TopInstall as per Sections 7 Caulk all seams to prevent leaks Refer to FigureInstall Termination Cap ST1175/ST475 Square Termination CapInstalling a TCT1175 Terra Cotta Cap TCT1175 Terra Cotta CapShrouds Radiation ShieldField Constructed Shrouds Mailbox Style Shroud radiation shield required Finishing Hearth Extension= 1/k x inches of thickness High temperature sealant Finishing MaterialFireplace opening 1194 mm Width of fireplace 305 mm Combustible MantelAccessories Gas Log/Lighter ProvisionWood Burning Inserts Gas Code, Ansi Z223.1Fireplace Dimensions Reference MaterialsHeat & Glo HST-48D US-CAN Rev F 11/081676 mm 508 mm 13 mm Chimney Components Catalog #457 mm Inside Diameter51 mm 25-1/439-7/8 711 mm 14-3/4 375 mm 584 mm Service Parts HST-48DDo not Discard this Manual