Hearth and Home Technologies HST-48D Glass Doors, Vented Gas Log Sets & Gas Log Lighters

Page 9

H. Glass Doors

•Glass doors are optional.

•Refer to Figure 2.2 for how to properly use them.

WARNING! Risk of Fire! Install ONLY doors ap- proved by Hearth & Home Technologies, Inc.

WARNING! Risk of Fire and Smoke! Fireplaces equipped with doors should be operated only with doors fully open or doors fully closed. If doors are left partly open, gas and flame may be drawn out of the fireplace opening.

FULLY OPEN

PARTLY OPEN

CORRECT

INCORRECT

FULLY CLOSED

PARTLY CLOSED

CORRECT

 

INCORRECT

 

 

 

 

 

 

Figure 2.2 Operating Positions of Bi-fold Doors

J. Vented Gas Log Sets & Gas Log Lighters

•Optional

•Vented gas logs or gas log lighters can be installed in this fireplace. Follow the instructions provided with the accessory for operation.

WARNING! Risk of Fire or Asphyxiation!

•DO NOT install unvented gas logs.

•Damper must be locked open.

•Gas flame may generate fumes.

K. Optional Components

•Other options may be available

•Consult your dealer/distributor

WARNING! Risk of Fire! DO NOT install and or use any component not approved by Hearth & Home Tech- nologies Inc.

L. Clear Space

•Do not place combustible objects within areas indicated in Figure 2.3.

WARNING! DO NOT place combustible objects in front of the fireplace. High temperatures may ignite clothing, furniture or draperies.

•Mantel - avoid placing candles and other heat-sensitive objects on mantel or hearth. Heat may damage these objects.

I. Outside Air (optional)

The outside air kit supplies some combustion air for your fireplace. It may help reduce the effects of negative air pressure. (See Section 5.D.)

•Refer to Figure 2.1 for location of control

•Close the inlet to prevent cold drafts when the fireplace is not being used.

CAUTION! Risk of Burns! The outside air control handle is HOT when fireplace is in operation. Adjust BEFORE lighting fire.

48 in. (1219 mm)

 

Clear Space

12 in. (305 mm)

Front of Fireplace

Clear Space

 

Sides of Fireplace

 

(from the FP

 

opening)

Figure 2.3 Clear Space

Heat & Glo • HST-48D US-CAN • 4012-040 • Rev F • 11/08

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Operation Wood Burning FireplaceHot screen/mesh and glass doors will cause burns Fire RiskListing Label Information/Location GrateNumber Table of Contents Installer GuideUser Guide CONDITIONS, Exclusions & Limitation of Liability Warranty Hearth & Home Technologies Limited WarrantyHeat & Glo HST-48D US-CAN 4012-040 Rev F 11/08 Appliance Certification Listing and Code ApprovalsNon-Combustible Materials Combustible MaterialsOperating Instructions Your FireplaceHot glass will cause burns Starting a Fire Seasoned WoodGrate FirescreenVented Gas Log Sets & Gas Log Lighters Glass DoorsOptional Components Clear SpaceHardwood vs Softwood Wood FuelMaintainance and Service Chimney Inspection/CleaningDisposal of Ashes Check Firebox Refractory Glass CleaningInspect Grate Frequency As desiredStart Fire Problems Possible Cause Solution Troubleshooting GuideTypical Fireplace System Getting StartedDesign and Installation Considerations DraftNegative Pressure Frequently open doors Central heat outlets or returns Locating Fireplace & ChimneyTools and Supplies Needed Fireplace System RequirementsInspect Fireplace and Components Framing & Clearances Select Fireplace Location1676 mm Hearth Clearances to Combustible Materials ClearancesFrame the Fireplace Sidewalls/SurroundsThings to Consider Installation of FireplacePosition the Fireplace Place Protective Metal Hearth StripsYES Ft min. from top of uppermost chimney section to air inletInstall Outside Air Kit Hood Wire TiesOutside Air Maintain minimum height of chimney above roof Chimney AssemblyC,f Chimney RequirementsExample Using Offsets/ReturnsAssemble Chimney Sections Install Chimney Air KitInstalling the Ceiling Firestop Install Ceiling Firestops330 mm Install Attic Insulation ShieldComplete Installation Install FlashingCut out Hole in Roof Flat Roofs Chimney Termination RequirementsConstruct the Chase Chase InstallationsInstall Chase Top Install Fireplace & ChimneyInstall as per Sections 7 Caulk all seams to prevent leaks Refer to FigureST1175/ST475 Square Termination Cap Install Termination CapTCT1175 Terra Cotta Cap Installing a TCT1175 Terra Cotta CapShrouds Radiation ShieldField Constructed Shrouds Mailbox Style Shroud radiation shield required Finishing Hearth Extension= 1/k x inches of thickness Finishing Material High temperature sealantCombustible Mantel Fireplace opening 1194 mm Width of fireplace 305 mmGas Log/Lighter Provision AccessoriesWood Burning Inserts Gas Code, Ansi Z223.1Reference Materials Fireplace DimensionsHeat & Glo HST-48D US-CAN Rev F 11/081676 mm 508 mm 13 mm Catalog # Chimney Components457 mm Inside Diameter51 mm 25-1/439-7/8 711 mm 14-3/4 375 mm 584 mm HST-48D Service PartsDo not Discard this Manual

HST-48D specifications

Hearth and Home Technologies (HHT) is renowned for its commitment to innovation and quality in the hearth industry, and the HST-48D model exemplifies this dedication. The HST-48D is a versatile and efficient gas fireplace designed to enhance both residential and commercial spaces. With its modern aesthetic and impressive performance, it has become a popular choice among homeowners and builders alike.

One of the standout features of the HST-48D is its sleek design. Featuring a large viewing area, the fireplace allows for maximum visibility of the dancing flames while contributing to a contemporary décor. The clean lines and elegant finish make it a perfect fit for various interior styles, from traditional to modern. Optional decorative fronts and media options offer further customization, enabling homeowners to tailor the look of their fireplace to match their personal taste.

In terms of performance, the HST-48D boasts a high efficiency rating, ensuring that it not only provides warmth but does so in an eco-friendly manner. The fireplace operates on natural gas or propane, offering flexibility in terms of fuel choice, and its efficient burner system generates a significant amount of heat while minimizing energy consumption. This makes it an excellent option for both primary and supplementary heating.

The HST-48D is equipped with advanced technology to enhance user experience. The fireplace features a state-of-the-art electronic ignition system, allowing for reliable and easy starts. Additionally, the multi-function remote control gives users the ability to adjust the flame height, control the blower, and manage other settings with ease from the comfort of their chair.

Safety is another key characteristic of the HST-48D. It adheres to strict safety standards and includes features such as a tempered glass front to prevent accidental burns, ensuring peace of mind for families and pets.

Overall, the Hearth and Home Technologies HST-48D represents a fusion of aesthetics, technology, and safety. Its modern design, high efficiency, and user-friendly features make it a standout choice for those looking to enhance their living spaces with a reliable and stylish heating solution. Whether for relaxing evenings with family or entertaining guests, the HST-48D transforms any environment into a warm and inviting haven.
Top Page Image Contents