Hearth and Home Technologies SL-950TV-IPI-E Lighting Instructions IPI, Final inspection by

Page 11

I. Lighting Instructions (IPI)

The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. To prolong battery life, remove them when using the transformer.

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING INSTRUCTIONS

(IPI)

1. Turn off all electric power to the appliance.

A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burn- er. DO NOT try to light the burner by hand.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•DO NOT try to light any appliance.

•DO NOT touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. DO NOT use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

2. This appliance is equipped with an ignition

device which automatically lights the burner.

DO NOT try to light the burner by hand.

GAS

VALVE

3.

Wait five (5) minutes to clear out any gas.

 

Then smell for gas, including near the floor. If

 

you smell gas, STOP! Follow “B” in the Safety

 

Information located on the left side of this la-

 

bel. If you do not smell gas, go to next step.

4.

Turn on all electric power to the appliance.

WARNING: CAUTION:

5. To light the burner, flip the ON/OFF switch to

the “ON” position. (The ON/OFF switch may

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, al- teration, service or maintenance can cause injury or property damage. Re- fer to the owner’s information manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause can- cer, birth defects, or other reproductive harm.

Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.

Hot while in operation. DO NOT touch. Keep children, clothing, furniture, gaso- line and other liquids having flammable vapors away.

DO NOT operate the appliance with fixed glass assembly removed, cracked or broken. Replacement of the fixed glass assembly should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and propane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the alternate fuel.

Also Certified for Installation in a Bedroom or a Bedsitting Room.

For assistance or additional informa- tion, consult a qualified installer, ser- vice agency or the gas supplier.

include a wall switch if so equipped).

6. If the appliance will not operate, follow the in-

structions “To Turn Off Gas to Appliance” and

call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.Turn wall control or ON/OFF switch to “OFF”.

2.Turn off all electric power to the appliance if service is to be performed.

593-913F

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

Final inspection by

Heat & Glo • SL-550 / 750 / 950TV-IPI-E • 2119-900 Rev. H • 11/08

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Hot glass will cause burns What to do if you smell gasHomeowner Reference Information CongratulationsUser Guide Table of ContentsReference Materials Appliance SetupTroubleshooting CONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty BTU Specifications Listing and Code ApprovalsAppliance Certification Tempered Glass SpecificationsElectrical Codes High Altitude InstallationsNon-Combustible Materials Specification Combustible Materials SpecificationYour Fireplace Gas Fireplace SafetyOperating Instructions User Guide Decorative Doors and Fronts Fixed Glass AssemblyRemote Controls, Wall Controls and Wall Switches Fan Kit optionalFinal inspection by Turn off all electric power to the applianceOn position. The ON/OFF switch may Lighting Instructions IPIAfter Fireplace is Lit Frequently Asked QuestionsRemote Control Maintenance and ServiceMaintenance Tasks-Homeowner Glass CleaningLogs Maintenance Tasks-Qualified Service TechnicianGasket Seal and Glass Assembly Inspection VentingEither cobrahead or SIT Typical Appliance System Getting StartedAny such action may cause a fire hazard Design and Installation ConsiderationsTools and Supplies Needed Inspect Appliance and ComponentsNegative Pressure Model Minimum Framing and ClearancesSelecting Appliance Location Models Constructing the Appliance ChaseClearances Combustible Mantels Mantel and Wall ProjectionsVent Termination Minimum Clearances Termination LocationsModels Pipe Size Vent Information and DiagramsVent Guidelines Vent System ConfigurationVertical Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Wall and Ceiling Penetration FramingSecuring and Leveling the Appliance Installing Outside Air Kit Damper Assem- blyAppliance Preparation Gas and Electrical ConnectionsSecuring Vent Sections Installing Vent PipeAssembly of Vent Sections Install Attic Insulation ShieldGas Connection Gas InformationFuel Conversion Gas PressureCode CSA C22.1 Wiring RequirementsOptional Accessories Requirements Electrical InformationIgnition Module 3 VAC Transformer PLUG-IN Wall Switch Installation for Fan Optional Junction Box InstallationFinishing Dimensions of CombustiblesFacing Material Noncombustible Facing DiagramAccessories Appliance SetupRemove Glass Assembly Clean the AppliancePlacing the Lava Rock Lava Rock, Mineral Wool/Ember PlacementInstall the Log Assembly PIN Hole Air Shutter Setting Install the MeshInstall Trim and/or Surround Install HoodIntellifire Ignition System TroubleshootingSymptom Possible Cause Corrective Action Ues to spark, and main Reference Materials Appliance Dimension DiagramService Parts Log Set AssemblyAt Depot Service Parts ListSL-750TV-IPI-E SL-750TV-IPI-E SL-950TV-IPI-E Stocked SL-950TV-IPI-ESL-550 / 750 / 950TV-IPI-E Contact Information

SL-950TV-IPI-E, SL-550TV-IPI-E, SL-750TV-IPI-E specifications

Hearth and Home Technologies has long been a leader in the fireplace industry, renowned for blending innovation with functionality in their products. Among their impressive line-up, the SL-550TV-IPI-E, SL-750TV-IPI-E, and SL-950TV-IPI-E models stand out for their exceptional quality and advanced features, catering to various heating needs and aesthetic preferences.

The SL-550TV-IPI-E is designed for those wanting an efficient, stylish fireplace that fits seamlessly into modern living spaces. It offers a sleek design with expansive viewing areas, allowing for a captivating flame display. Its innovative IntelliFire Plus technology enhances convenience and efficiency by providing reliable, electronic ignition, which can be managed via a remote control. Noteworthy is the model's ability to operate with granular control, allowing users to adjust the flame height and heat output according to their needs.

Next, the SL-750TV-IPI-E steps up the game with its larger size and increased heating capacity. This model is perfect for medium to large rooms, providing excellent warmth while maintaining an elegant ambiance. Like the SL-550TV-IPI-E, it utilizes the IntelliFire Plus system for ease of use. In addition, it features a stunning firebox design that emphasizes authenticity with realistic logs and glowing embers, creating a true hearth experience. Its large viewing area enhances the visual impact, making it a focal point in any room.

Lastly, the SL-950TV-IPI-E is at the pinnacle of this series, offering the largest footprint and highest heating efficiency. Specifically designed for larger areas, this model not only delivers significant warmth but also serves as an impressive architectural feature. The SL-950TV-IPI-E integrates advanced heating technologies to maximize efficiency while minimizing fuel consumption. The remote control operation and customizable flame settings provide an exceptional level of convenience for homeowners.

All three models boast a range of customizable options, including finishes and surroundings, allowing them to fit a variety of decor styles. Their construction emphasizes quality, with durable materials designed to withstand the test of time. Furthermore, the sealed combustion system ensures safety and efficiency by drawing air from outside, reducing indoor air pollution.

In summary, the SL-550TV-IPI-E, SL-750TV-IPI-E, and SL-950TV-IPI-E models from Hearth and Home Technologies offer a harmonious blend of technology, aesthetics, and efficiency. Whether for ambiance or heating, these fireplaces provide a robust solution to enhance modern living spaces.
Top Page Image Contents