Niles Audio ZR-4 manual Configuring sources 2,3, Learning Precautions, Programming a Learned Key

NOTE: If a code digit is 0, the LED does not blink

5.Continue through five digits by pressing 2 for the second digit, 3 for the third, 4 for the fourth and finally 5 for the fifth; counting the TV Source Key LED blinks for each digit.

6.To check for other device codes, repeat steps 1—5, substituting the source key for the device you would like to check

configuring sources 2,3, and 4

These source device commands are learned directly from the original device remotes. There are some precautions to be observed:

Learning Precautions

Your original remote control device must be in working order to learn IR codes properly.

•Learned keys are device specific, so each key can store a unique function for each device

•Do not use the following keys for learning: Source Keys or SETUP.

•Learning capacity is approximately 42 to 75 keys, depending on the code being learned

•Certain device functions cannot be learned, including multi-frequency types, some high frequency ones, and other unusual formats

•For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights

NOTE: Please have your original remote controls handy before programming learning

Programming a Learned Key

NOTE: If more than 10 seconds pass between key presses, the remote exits programming

1.Place the Niles R-6L Hand-Held Learning Remote Control head-to-head (about 2” apart) from your original remote control.

2.Locate the key (on your original remote control) that you want the R-6Lto learn.

3.Press the device key for which you wish to learn IR commands.

4.Press and hold SETUP until the Source Key LED blinks twice, then release.

5. Enter 9 7 5. The Source Key LED blinks twice.

NOTE: If the LED displays one long flash instead, your batteries are low, or the R-6L memory is full. In either case, the remote cannot learn a new key.

6.Press the key on the Niles R-6L remote for which you wish to learn a command. The Source Key LED will blink rapidly for three seconds, indicating the remote is ready to learn.

7.On the original device remote, press-and-hold the key to be learned. Continue holding the key on the original remote until the R-6L’s Source Key LED blinks twice.

NOTE: If the source key LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture is obtained.

If the function is still not captured, press and hold SETUP to exit programming and review the “Learning Precautions” above. If needed, also see “Troubleshooting”. After review, start programming again at step 1.

8.Repeat steps 6 through 7 for each key to be learned. Once all keys are learned, press-and-hold SETUP until the Source Key LED blinks twice to save all data learned.

Deleting a Single Learned Key

This process returns a single key to its original programming for the selected device only. Learned programming can also be deleted by teaching a different function to the key (see “Programming a Learned Key”).

NOTE: If more than 10 seconds pass between key presses, the remote exits programming.

1.Press the Source Key for the device for which a learned key is to be deleted.

2.Press-and-hold SETUP until the Source Key LED blinks twice, then release

3.Enter 9 7 6. The Source Key LED blinks twice

4.Press the key containing the learned function to be deleted twice. The Source Key LED blinks twice and the R-6L exits from programming mode.

Deleting All Learned Keys FOR a Spe- cific device

NOTE: If more than 10 seconds pass between key presses, the remote exits programming.

1.Press-and-hold SETUP until a Source Key LED blinks twice, then release

24 NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373