Lux Products TX9100E warranty AIR Filter Monitor, Advanced Features, Swing and Offset Settings

Page 24

AIR FILTER MONITOR

In systems that have a blower fan and air ducts, this feature is to assist you with proper maintenance and periodic replacement of the filter located in your heating or cooling system. The Air Filter Monitor counts the duration of filter usage that has occurred, since the last time the Filter Monitor has been reset. The Air Filter Monitor is for information only, and does not affect the operation of your heating or cooling equipment. When the filter usage duration has expired, the words “CHANGE FILTER” will appear at the bottom of the display as a reminder while in Run mode.

To set and use the Air Filter Monitor, turn the dial to AIR FILTER. The display will show the amount of filter usage remaining. To reset the usage counter, or change the filter usage duration, press the NEXT button. “SET: FILTER DAYS” will be displayed on the screen, along with a number of days. The available settings are: OFF, 30, 60, 90, 120, 180, or 365 days. If your system does not have a filter, setting the value to OFF will prevent the “CHANGE FILTER” from showing up on the screen. Return the rotary dial to the RUN position when you are finished adjusting the Air Filter Monitor settings.

12. ADVANCED FEATURES

SWING AND OFFSET SETTINGS

SWING: A thermostat works by turning your heating or cooling system on and off whenever the room temperature varies from the set-point temperature. The amount of this variation is called the swing. Your system should cycle on about 3 to 6 times per hour. A smaller swing number increases the number of cycles per hour, so the room temperature is more precise and constant. A larger swing number decreases the number of cycles per hour, but can

24

Image 24
Contents Installation and Operating Instructions TX9100ESystem Compatibility Compatible withNot Compatible with Thermostat Features Tools RequiredSelecting a Location Remove OLD Thermostat Mount the NEW ThermostatWiring Information and Diagrams Connecting the Wires Wiring Diagram NotesPage Typical 24-VOLT, 2 or 3 WIRE, Conventional Typical 24-VOLT, CONVENTIONAL, 1-STAGE, HOT Water Factory RH-RC Jumper Wire Installed Systems with 1 Stage Heat and 1 Stage Cool Heat Factory Supplied RH-RC Customer Supplied Typical 24V, 5 WIRE, Heat Pump Systems RC G Hardware Setup Options Option SwitchesGAS/ELEC. FAN Operation System Mode RecoveryDelay Battery Monitor Completing the InstallationScale Reset Mode SwitchesFront Panel Items Push Buttons Rotary DialOperating Instructions SET DAY/TIMEHeating and Cooling Wait IconTemperature Override Temperature HoldEmergency Heat Heat Pump Configuration Only Display BacklightAdvanced Features Swing and Offset SettingsAIR Filter Monitor Degrees F User Temperature Calibration Programmable Keypad Lock536PM 72 F Page Quick Copy Feature ProgrammingSET Heat Program SET Cool ProgramBatteries and Maintenance 536PM 72 FTechnical Assistance Warranty 536PM 72 F