Lux Products TX9100E warranty Front Panel Items, Reset, Mode Switches

Page 19

NOTE:

When you are finished performing your installation and setup options, please remove the thin plastic film that is protecting the LCD display screen on the front of the thermostat. This plastic may or may not be present, and is evident by the appearance of fake digits appearing on the display screen.

10. FRONT PANEL ITEMS

RESET

The RESET button is a small recessed push button that is located right above the NEXT button behind the front door. This button can be pushed with a pencil or the end of a paper clip. This reset returns the heating and cooling programs to their default Energy Star values, resets the filter counter, and all other user changeable software options to their default values. It is recommended that you write down your current heating and cooling program start times and temperatures prior to pressing the software reset button.

MODE SWITCHES

There are two mode switches on the front, a TEMPERATURE Mode switch and a FAN Mode switch.

The TEMPERATURE Mode switch has three positions: HEAT, OFF, and COOL. In the winter, set the switch to HEAT to control your heating system. In the summer, set the switch to COOL to control your cooling system. In the spring and fall or when the windows are open, you can set the switch to OFF to prevent heating or cooling operation.

The FAN Mode switch has two positions, AUTO and ON. Setting the Fan switch to AUTO automatically runs your system's blower fan as required, only during heating or cooling activation. Setting the Fan switch to ON, runs your system’s fan continuously, even if heating or cooling is not

19

Image 19
Contents TX9100E Installation and Operating InstructionsCompatible with System CompatibilityNot Compatible with Tools Required Thermostat FeaturesSelecting a Location Mount the NEW Thermostat Remove OLD ThermostatWiring Diagram Notes Wiring Information and Diagrams Connecting the WiresPage Typical 24-VOLT, 2 or 3 WIRE, Conventional Typical 24-VOLT, CONVENTIONAL, 1-STAGE, HOT Water Factory RH-RC Jumper Wire Installed Systems with 1 Stage Heat and 1 Stage Cool Heat Factory Supplied RH-RC Customer Supplied Typical 24V, 5 WIRE, Heat Pump Systems RC G Option Switches Hardware Setup OptionsGAS/ELEC. FAN Operation Recovery System ModeDelay Completing the Installation Battery MonitorScale Mode Switches ResetFront Panel Items SET DAY/TIME Push ButtonsRotary Dial Operating InstructionsWait Icon Heating and CoolingTemperature Hold Temperature OverrideDisplay Backlight Emergency Heat Heat Pump Configuration OnlySwing and Offset Settings Advanced FeaturesAIR Filter Monitor Degrees F Programmable Keypad Lock User Temperature Calibration536PM 72 F Page SET Cool Program Quick Copy FeatureProgramming SET Heat Program536PM 72 F Batteries and MaintenanceTechnical Assistance Warranty 536PM 72 F