TO CHANGE THE LOCK CODE: First ensure that the thermostat is unlocked and the rotary dial is in the RUN position. Press the NEXT button for at least 2 seconds. The words “ENTER CODE” will appear on the screen, above “0000”. Now press the HOLD button for at least 2 seconds. The words “SET CODE” will appear on the screen, along with “0000”. Enter your desired code by using the UP/DOWN buttons to change the flashing digit, and the NEXT button to advance to the next digit. Press the NEXT button again for at least 2 seconds. Enter your new code to lock the thermostat, or you may wait for 12 seconds to exit automatically without locking the thermostat.
IF YOU HAVE FORGOTTEN YOUR LOCK CODE: You can reset the code to “0000” and then unlock the thermostat. On the back of thermostat, locate JP1, which is a row of 3 gold pins at the right edge of the circuit board above the battery tray. There should be a plastic jumper cap on 2 of the 3 pins (either right or left).
JP 1
Remove the jumper cap, and place it on the opposite 2 pins. Move the Temperature Mode switch on the front to any other position than its current one. The lock code should now be the default of “0000”, but still be in a locked state. Follow the instructions listed in “UNLOCKING THE THERMOSTAT”, and use the “0000” when entering the code.
28