Aprilaire 8556 owner manual Following procedure must beFigure 1 carefully followed

Page 25

110-791B 7/12/01 8:58 AM Page 25

To change the DIP switch settings, the thermostat must be removed from the base which is attached to the wall.

The power to the thermostat must be turned off before disassembling or the thermostat can be permanently damaged. If you do not know where the switch is that

controls the power to your thermostat, do not attempt to access the DIP switches. The

following procedure must beFigure 1 carefully followed:

a)Turn off power to the thermostat.

b)Completely open the thermostat cover. The cover will snap into this position.

c)Carefully insert a medium- sized flathead screwdriver into the latch access slot (see Figure 1).

CAUTION: TO PREVENT DAMAGE, AVOID CONTACT WITH BLUE TEMPERATURE SENSOR ON BOTTOM RIGHT- HAND CORNER OF THERMOSTAT CIRCUIT BOARD.

– 23 –

Image 25

Contents Model Cooling Temperature ControlEquipment Control Energy Star Program Information Cool = 78˚ Heat = 70˚Heat = 62˚ Cool = 85˚Change the flashing symbol to the current day Week Setting Or Changing The Clock110-791B 7/12/01 857 AM Progressive Recovery Setting Or Changing The Program110-791B 7/12/01 857 AM Heat = Cool = Program ScheduleSetting Or Changing Program Times Night Press and release the program button. The DaySetting Or Changing Heating Temperatures Setting Or Changing Cooling Temperatures Press and release the Mode button until the word To Start Running The Program Reviewing Programmed Time Schedules Temperature SettingsThermostat Operation For Best Performance110-791B 7/12/01 858 AM Return to the program Temperature ControlTime Control Equipment Control 110-791B 7/12/01 858 AM Optional Settings For Additional Thermostat Features 110-791B 7/12/01 858 AM 110-791B 7/12/01 858 AM Following procedure must beFigure 1 carefully followed See Figure Place ThermostatTurn the thermostat power back on Case Of Power Failure Using The Available LED IndicatorsCleaning Limited Warranty BOX 1467 MADISON, WI