Metz A-Remote mode

Metz a distanza senza cavi in Modo Auto

Funcionamiento Remoto A de Metz

Set a shutter speed of 1/60th sec. or slower.

Switch on the mecablitz on the camera with the main switch.

Depress the MODE button repeatedly until A appears on the display.

While the A mode is flashing, turn the setting disk and select the address Ad1 or Ad2 for the Co controller mode. Depress the MODE button in the event that A no longer flashes. To store, briefly press the setting disk in the direction of the arrow. The selected setting will be automatically stored after 5 seconds if the setting disk is not pressed. A will then be continuously displayed (without flashing), together with Co and the slave address Ad1 or Ad2.

Setting procedure for Metz auto remote slave mode:

The setting procedure is the same as for Metz TTL remo- te slave mode.

7.3Assessing the overall lighting conditions in remote mode

A modelling light beam of all participating flash units can be fired to assess the overall lighting conditions in A (auto) and TTL remote mode.

For this purpose, the button of the 54 MZ-3 mounted on the camera must be programmed. Press the Select

button repeatedly until the mode display lights up. Turn the setting disk to set the modelling light function to ON or OFF. The modelling light can then be fired with the button; see also Chapter 12.

46

Page 46
Image 46
Metz 54 MZ-3 Assessing the overall lighting conditions in remote mode, Setting procedure for Metz auto remote slave mode