Exposure corrections

Compensazione dell‘esposizione manuale

Correcciones de exposición

after 5 seconds if the setting disk is not pressed. The arrow symbol alongside „EV“ ceases to flash. The set value is displayed on the LC display of the mecablitz.

Deactivating manual flash exposure correction:

Turn the setting disk until the arrow symbol appears alongside „EV“ on the LC display.

Press the setting disk. The arrow symbol alongside „EV“ starts to flash.

Turn the setting disk until the displayed correction value is extinguished on the display.

Press the setting disk in the direction of the arrow to confirm deactivation. If the setting disk is not pressed the function is automatically deleted after 5 seconds. The arrow symbol alongside „EV“ ceases to flash.

Manual flash exposure correction is only possi- ble if the camera supports this function! If the camera does not support this function, the cor- rection value can be adjusted on the mecablitz, but cannot become effective!

Transmission of a correction value for flash exposure from the mecablitz to the camera is only possible in TTL mode with an SCA 3xx2 adapter which supports this function.

With some cameras, manual flash exposure corrections must be adjusted on the camera (see the operating instructions for the given camera). In this event the mecablitz will not display a correction value.

Some cameras permit manual flash exposure corrections to be completed on the camera or on the flash unit. Please refer to the operating instructions for the given camera or the SCA adapter to establish which setting has priority.

84

Page 84
Image 84
Metz 54 MZ-3 operating instructions Deactivating manual flash exposure correction