Clock Chimes
Battery Installation and Setting Time
Note: This feature is only available on specific models.
1. Install battery into clock. Firmly grasp brass ring and carefully pull forward to remove clock assembly from front of chime. Gently pull off bat- tery cover located on back of clock assembly. In- stall "AA" battery according to polarity marks in- side battery chamber. Replace battery cover.
2.Set time. With battery cover removed, turn
time setting dial on back of clock assembly until time is correct. Replace battery cover. Replace clock assembly into chime face by pressing as- sembly gently into hole on chime face.
3.Install batteries into chime. Remove clock chime back. Grasp cutouts on back of chime with fingers. Gently push back up and pull lower part of back out to remove. Install 3 alkaline "D" batteries ac- cording to polarity marks inside battery chamber. Replace back of chime by following the above instructions in reverse (see illustration on page 1).
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on your chime and push button.
The push button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the push button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Other wireless prod- ucts may cause interference and the system may not function properly. Fol- low the instructions below for setting a new code.
1.Open the cases and locate the jumpers on both the push button and chime (See illustration on page 4).
2.The push button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.
3.To change the code, add and/or remove jumpers as needed. It is recom- mended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the push button and chime for this system to function.