LG Electronics 1400HT Residential Standard Manufactured Mobile Home Standard, Important Notes

Page 11

INSTALLATION

See Pipe Manufacturers Instructions For Installation Requirements Of Venting Components And Vent Clearances.

RESIDENTIAL STANDARD

MANUFACTURED (MOBILE) HOME STANDARD

Using 6” (152 mm) Diameter Single Wall Con-

Using 6” (152 mm) Diameter Type L-Vent Connector Pipe

nector Pipe. Not Approved For Manufactured

 

(Mobile) Homes.

 

IMPORTANT NOTES:

•Minimize the use of elbows (30°, 45° or 90°) - Offsets in the venting system are very restrictive and will inhibit the draft (i.e. You will lose approximately 5 feet of effective draft for every 90 degrees of direction change). This appliance requires 12 to 15 feet of effective draft for optimum performance (see Draft Requirements on page 10).

•First section of pipe must be vertical - Use as much straight verti- cal pipe directly above the appliance as possible before using an elbow (a 2’ to 3’ initial vertical rise is suggested).

PAGE 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents 775000M, Rev. G, 12/03 EPA Certified Wood Burning Stove Retain These InstructionsReference Important Warnings Table of Contents Selecting a Location Planning Your InstallationSmoke Detectors Optional Arch Treatment Corner Installation Parallel Alcove ClearanceCombustible Wall Clearance Alcove ClearancesProtected Wall Clearance Reduced Masonry Structure Clearance AlcoveFloor Protection Standard Parallel Hearth PAD ShownGrounding Stove InstallationSecuring the Stove to the Floor Manufactured Mobile Homes OnlyChimney Inspection Acceptable Connector Pipe for INSTALLA- TionsTypes of Chimneys 2’ by 10’ Rule for Vent Termination Chimney Height RequirementsDraft Requirements Draft Test ProcedureImportant Notes Residential Standard Manufactured Mobile Home StandardPenetration Solid-Pak chimney section shall be flush with the insideFuel Door Door Operation Product Features and ControlsCare and OPERATI0N Primary AIR ControlBREAK-IN Period USE Control Settings That Work for YOUHOW to Start and Maintain a Fire Care and OperationFuel MaintenanceServicing Glass Reinstall Baffle BrickCleaning Blower Intake Door and Glass GasketsTroubleshooting Overfiring Damage Specifications Model 1400HT Description Primary AIR Draft Module Door AssemblyHandle Assembly P/N LB-102214 Stove-Stat Kit Outside Air Floor Duct OAFD-RBlower Kit SAFETY/LISTING Label EPA Label Ownership Records Service and Maintenance LOGWest Taft Avenue Orange, CA
Top Page Image Contents