Combustible Wall Clearance

PLANNING YOUR INSTALLATION

WARNING: IT IS VERY IMPORTANT THAT YOU OB- SERVE THE MINIMUM CLEARANCES.

There are listed clearances for your stove which were determined in a Laboratory test using various "classes" of stove pipe or chimney. Minimums are first estab- lished for the stove itself and increased based on how much heat is transferred by each class of pipe.

Note: Manufactured (mobile) home installations require the use of a Type L Vent Chimney connector only. Use of a single wall flue pipe connection is not permitted.

Residential Reduced Clearance

Using Listed L-Vent pipe (double wall air insulated) to the top of the stove. Approved brands are: Jakes- Evans, Dura-Vent, Security, Pro-Vent, Ameri-Tek, Metal Bestos.

Clearances (inches / millimeters)

A. 10	½ / 267	C. 15	/ 381	E. 9 ½ / 241
B. 20	/ 508	D. 8 /	203	F. 5 / 127

Residential Standard (not approved for manufac- tured [mobile] homes)

Using single wall pipe connector to the top of the stove.

Clearances (inches / millimeters)

A. 15 / 381	C. 15 / 381	E. 8 ½ / 216
B. 19 / 483	D. 13 / 330	F. 5 / 127

Manufactured (Mobile) Home Standard Clearance Using Approved L-Vent only. Approved brands are Dura-Vent, Security, Pro-Vent, and Ameri-Tek. Manu- factured (Mobile) Home installations must use a rain

cap with a spark arrester.
Clearances (inches / millimeters)
A. 10	½ / 267	C. 15 / 381	E. 9 ½ / 241
B. 20	/ 508	D. 8 / 203	F. 5 / 127

CORNER

INSTALLATION

PARALLEL

INSTALLATION

*ALCOVE CLEARANCE

Required pipe: Type L-Vent pipe to top of stove. Ap- proved brands are Dura-Vent, Pro-Vent, Ameri-I-Tek, Standex, and Metal Bestos.

Alcoves must have minimum dimensions of 84" (213 cm) height minimum, 46" (117 cm) width minimum and 24" (610 mm) depth maximum.

ALCOVE CLEARANCES:

Back wall to pipe O.D.	10 1/2" (267 mm) Minimum
Side wall to pipe O.D.	20" (508 mm) Minimum
Back wall to stove	8" (203 mm) Minimum
Side wall to stove	9 1/2" (241 mm) Minimum

*NOTE: Alcove dimensions cannot be reduced by the use of non-combustible materials such as brick, stone, etc. Alcove dimensions listed are minimum dimensions and are not measurements for building an Alcove. You will need to consider these clear- ances, as well as other dimensional requirements before you build the alcove and install this appliance.

OPTIONAL ARCH TREATMENT

An alcove depth of 24" (610 mm) (or less) will allow for a minimum height of 84" (213 cm) and may be trimmed with a 2 1/4" (57 mm) maximum arch treatment if de- sired.

PAGE 5