LG Electronics LP091HEM-Y8 manual Electrical Parts, Shroud, Outdoor Motor, Compressor, Capacitor

2.2.4 SHROUD

1.Remove the axial fan. (Refer to section 2.2.3)

2.Remove the 4 screws which fasten the condenser with the shroud and the basepan. (See Figure 11)

3.Remove the shroud.

4.Re-install the component by referring to the removal procedure.

2.3. ELECTRICAL PARTS

2.3.1 OUTDOOR MOTOR

1.Remove the clamp cord and disconnect a wire housing in control box. (Refer to section 2.1.2)

2.Remove the axial fan. (Refer to section 2.2.3)

3.Remove the 2 screws which fasten the motor. (See Figure 14)

4.Remove the motor

5.Re-install the component by referring to the removal procedure, above.

2.3.2INDOOR MOTOR (Refer to section 2.2.2)

2.3.3COMPRESSOR

1.Discharge the refrigerant system using a refrigerant recovery system.

If there is no valve to attach the recovery system, install one (such as a WATCO A-1) before venting the refrigerant. Leave the valve in place after servicing the system.

2.Disconnect the 3 leads from the compressor.

3.After purging the unit completely, unbraze the suction and discharge tubes at the compressor connections.

4.Remove the 3 nuts and the 3 washers which fasten the compressor. (See Figure 15)

5.Remove the compressor.

6.Re-instill the components by referring to the removal procedure, above.

Figure 13

Figure 14

Figure 15

2.3.4 CAPACITOR

1. Remove the control box. (Refer to section 2.1.2)

2. Remove 1 screw and disconnect the leads which connected to the box type capacitor.

(See Figure 16)

3. Remove 1 screw and the clamp which fastens the can-type capacitor.

4. Disconnect all the leads of capacitor terminals.

5. Re-install the components by referring to the removal procedure, above.

	Figure 16
Copyright ©2008 LG Electronics. Inc. All right reserved.	- 12 -
Only for training and service purposes	LGE Internal Use Only