LG Electronics LP091HEM-Y8 manual Disassembly Instructions, Mechanical Parts, Front Grille

2. Disassembly Instructions

—Before the following disassembly, POWER SWITCH is set to OFF and disconnected the power cord.

2.1 MECHANICAL PARTS

2.1.1 FRONT GRILLE

1.Remove the front grille. (See Figure 1)

2.To remove the front grille, pull out the bottom of the front grille and then lift up.

Re-install the component by referring to the removal procedure.

3.To replace the front grille, place the tabs over the top of the unit and push the bottom of front grille until the clips snap into place.

•This Room Air Conditioner (PTAC) discharges air from the top of the unit through reversible, 2-position discharge grille louvers. The unit is shipped from the factory with the discharge grille louvers at an angle of 40˚ off vertical. In the alternate position, the louvers will be at an angle of 15˚ off vertical.

Figure 1

40˚

15˚

To adjust air direction, remove the front grille. Remove the 4 screws that fasten the discharge grille to the front grille.

Flip the discharge grille 180°, then reattach the discharge grille to the front grille with 4 screws.

Screws

Copyright ©2008 LG Electronics. Inc. All right reserved.	- 8 -
Only for training and service purposes	LGE Internal Use Only