Shark V1725 owner manual Removal of Battery Pack, Modèle Volts CC, Battery Removal & Disposal

Page 8

Battery Removal & Disposal

NOTE: If uncertain as to how to remove your battery pack, we suggest you take your sweeper to a reputable small appliance service technician to have this service performed.

Follow these steps when battery removal is required.

This sweeper is equipped with Ni-Cd batteries and you need to dispose of them properly. When the batteries are no longer good for use, they must be removed from the sweeper for disposal. Do not remove the batteries for any reason other than disposal of them. Call your nearest recycling center for information on the recycling and disposal of Ni-Cd batteries.

WARNING: You must never use ordinary batteries for replacement as these may leak and cause damage. Use only battery pack X8905 provided for replacement.

Removal of Battery Pack

1.Remove the extention handles and dust cup container.

2.Turn unit over so that the base is facing upwards. Be careful not to turn the unit ON. (Fig. 9)

3.Push in locking tab and lift off battery compartment cover. (Fig. 10)

4.Lift out battery pack and set aside.

5.Insert the new battery pack into unit, ensuring that the Positive (+) terminal of the battery pack corresponds with the positive (+) making inside the battery compartment. Replace the battery compartment cover making certain that the locking tab snaps in place.

IMPORTANT: This appliance contains Ni-Cd batteries. The batteries must be recycled or disposed of properly.

Locking

Tab

Fig. 9

Fig. 10

7

Modèle: V1725

4,8 volts CC

1.

Tête motorisée

7.

Prise de recharge

2.

Interrupteur marche/arrêt

8.

Poignée inférieure

3.

Témoin de recharge

9.

Poignées de rallonge en métal

4.

Coupelle à poussière

10.

Poignée supérieure

5.

Brosse rotative

11.

Adaptateur de recharge :

6.

Couvercle de brosse transparent

 

N’utilisez que TechWorld AD-0720-

 

 

 

UL-8 7,5V-200 mA ou AD-0815-UL-8

 

 

 

7,5V-150mA

Les illustrations peuvent différer du produit réel.

REMARQUE: Le balai motorisée sans cordon modèle

V1725 est expédiée avec des piles non chargées. Charger les piles pendant 16 à 20 heures avant d'utiliser l'appareil. N’utiliser que des piles de rechange X8905.

20

Image 8
Contents Garantie Limitée D’UN 1 AN Model/ Modelo/ ModèleImportant Safeguards Problème Cause Possible Solution PossibleFor Household USE only Soin ET Entretien DE LA PoussièreRetrait DU BLOC-PILES Model Volt DCRetrait ET Mise AU Rebut DES Piles Assembling Your Cordless Sweeper Recharge DE LE Balai Motorisée Sans CordonRangement DE LE Balai Sans Cordon Before you startHOW to Operate Your Cordless Sweeper Nettoyage DE LA Coupelle À PoussièreCleaning the Dust Container Fonctionnement DE LE Balai Sans CordonAssemblage DU Balai Sans Cordon Avant de commencer Charging the Cordless SweeperStoring the Cordless Sweeper Modèle Volts CC Removal of Battery PackBattery Removal & Disposal Care and Maintenance Troubleshooting GuideProblem Possible Reason Possible Solution Conserver CES InstructionsONE 1 Year Limited Warranty Garantía Limitada DE UN 1 AÑOTarjeta DE Registro DE Propiedad Solo Que Consumidor CanadienseGuía Para Diagnóstico DE Problemas Problema Causa Posible Solución PosibleConserve Estas Instrucciones Cuidado y MantenimientoDesmontaje DEL Paquete DE Pilas Modelo Volt DCDesmontaje Y Desecho DE LAS Pilas Recarga DEL Barredor Inalámbrico Guardado DEL Barredor InalámbricoEnsamblaje DEL Barredor Inalámbrico PrecauciónOperación DEL Barredor Inalámbrico Limpieza DEL Contenedor DE Polvo