ST-3050D SUB. PUMP/CTRL. BOX — TRANSFORMER WIRING (CB200)
TRANSFORMER 230/460VOLTAGE SETTINGS
CAUTION:
Transformer 230/460 Voltage Settings: Pump motors are factory set at 230 VAC.The transformer (Figure 6) of this control box must be set to the voltage requirements of the pump in use. Refer to the attached wiring diagram
located inside the "Control Box" or reference Figures 7 & 8. Use the two supplied jumper tabs to set the transformer to the required output voltage.
NOTE
Transformer settings are for CB 200 Control Box only!
WARNING:
ALWAYS make sure that the transformer is set to the correct output voltage. Incorrect transformer output voltage settings can cause severe damage to the pump.
Figure 6. Transformer AC Voltage Settings (Jumper Tabs)
PAGE 16 —