Sears 385. 17928 owner manual 0L, Sew a Button

Page 42

Sew a Button

Set the Machine

Stitch width control

Must be adjusted

t 213 4

Top thread tension control 2 to 6

Stitch length control

Any number (not necessary to adjust)

f

		/
	/	/
	/	J
		J
		\
	x.	j

0L\ ))"

Stretch Stitch

A: Zigzag foot

l,

Drop the feed dogs (see page 32).

1.Match the center of the button holes to the center of the slot foot.

2.Adjust the stitch width so that needle will drop in each hole.

3.Lower the foot to hold the button in place.

Turn the hand wheel by hand _v_ that needle ,,,:it,,,,,enter either button.

To strengthen the shank, cut the

on the presser threads leaving a 8" tail. Bring the needle thread down through the hole in the button and wind it around the

shank.

Draw the thread to the bottom side ] ,,o,__" v,_ *_'_,,_and knot.

Drop feed lever -_

4. Stitch several times.

When finished, raise the feed dogs

(see page 32).

4O

Image 42

Contents Sewing Machine SEARS, Roebuck and CO Important Safety Instructions Table of Contents Page ArmCoverPlate Page Plug in the Machine and Switch on the Power Safety FeatureSet the Pressure Dial Adjust the Presser Foot Lever Thread CutterTo Attach To removeEtc Check the PresserFoot PresserFoot Types Change the Presser FootStitcing Presser Foot Types Sliding Buttonhole FootChoose e Needle and Thread Check the NeedleFabric, Needle, Thread and Stitch Length Chart To Change the NeedleTo Remove the Bobbin from the Machine Horizontal Spool Pin Additional Spool PinFirmly against the thread spool Ordinary SpoolBobbin Winding Insert the Bobbin into the Bobbin Holder So that ThreadPrepare the Top Thread Thread the NeedlePick Up the Bobbin Thread Adjust the Top Thread Tension IIIFor Zigzag Stitch Top tension Too Tight Too Loose Just RightGuide messagewindow Rickrack stretch Reverse III Zigzag 38Red 3N5Refer to Herring Bone StretchButtonhole Twin Needle Stitches Satin Stitch Acceptable resu Its Set the Machine DarningDropping the Feed Dogs 213Topstitching Sew in a Zipper On the zipper footOpenthezipper Basic Zigzag Stitch width control 1 to Set the Machine MonogrammingWtu Chalk Satin Stitch 234Stitch Length Control Bar Tacking Sew 4 to 6 zigzag stitchesEmbroidery FeedSee 0L\ Sew a ButtonOvercasting Stitch Zigzag footBlind Hemming Set the Machine Control 2 to 6Stitch length control redFor LaceWork Set the Machine Stitch width Control 2 to 213 Three-Step Zigzag Zigzag footControl 3 to Box StitchingShell Stitching Set the Machine Stitch width control 3 to Stitch lengthTwo-point Shell Stitch Fagoting StitchTwo-point Box Stitch Overedging StitchUseful to join elastic Foot Decorate with Geometric PatternsSatin stitch Stretch StitchStraight Stretch Zigzag foot Stitch and Its Uses Serging or Pine Leaf Stretch Stitching Elastic Stretch StitchSet the Machine Stitch width control 3 to Herring Bone Stretch Stretch Patching Set the MachineDecorative Stretch Patterns Top thread tensionLength control #3t Vests, jackets or coatsStitch Built-in System213-4 SliderSet the stitch selector at U Sew 4 to 6 stitchesStop sewing at the left stitch More Varied Using Buttonhole AttachmentTemplate 213504005 213505006 213506007 Sizes 15/16 WillOptional Item Pins a Stitch length control 3 toOptional Item Leave 3 to 4 inches of threadOptional Item Coarse stitches Set the Machine For any of these stitch Stitch width Satin stitch footIllustration a Problem Probable Cause UpperProblem Page Page Parts List 647814042 Single 647814020 No Single Needles647814031 No. !4 Single Needles Nuuou IruR 647814053 No Single NeedlesStorage box Additional Spool Pin Appliqueing Bar tacking Base plate Basic zigzag3435 3648Zigzag Overcasting Zipper Zipper Foot 13, 26,3435,6667Warranty SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, ILSEARS, Roebuck and CO., Chicago, IL60684 U.S.A 385