Sears 385. 17928 owner manual

Page 67

Open face cover plate and oil two points as shown below at least once a year. One or two drops of oil is sufficient.

Remove excess oil, otherwise it may stain fabrics.

1.Unplug the machine and remove 5. Take out the bobbin. Lift up the

the presser foot and needle.

bobbin holder and remove it.

 

2.Remove the bobbin cover plate.

3.Remove the screw on the left side of the needle with the large screw driver.

4.

Remove the needle plate.

In case

machine

is

not used

for an

 

 

 

 

 

 

 

 

extended

time,

oil

it

before

sewing.

 

 

Use good

quality

sewing

machine

oil:

No other oiling is required

Above points are only area which require oiling on this machine.

J

6.Use the lint brush to clean the Line up the triangle marks and

feed dogs, hook

race

and

bobbin

position

the bobbin holder so the

holder.

Also use

a soft,

dry

cloth.

notch fits next to the stopper in

 

 

 

 

 

 

 

the hook

race.

65

Image 67
Contents Sewing Machine SEARS, Roebuck and CO Important Safety Instructions Table of Contents Page ArmCoverPlate Page Safety Feature Plug in the Machine and Switch on the PowerSet the Pressure Dial Thread Cutter Adjust the Presser Foot LeverTo remove To AttachEtc Check the PresserFoot Change the Presser Foot PresserFoot TypesStitcing Sliding Buttonhole Foot Presser Foot TypesCheck the Needle Choose e Needle and ThreadTo Change the Needle Fabric, Needle, Thread and Stitch Length ChartOrdinary Spool Additional Spool PinFirmly against the thread spool To Remove the Bobbin from the Machine Horizontal Spool PinBobbin Winding So that Thread Insert the Bobbin into the Bobbin HolderThread the Needle Prepare the Top ThreadPick Up the Bobbin Thread III Adjust the Top Thread TensionTop tension Too Tight Too Loose Just Right For Zigzag StitchGuide messagewindow Rickrack stretch Reverse III Zigzag 3N5 38RedHerring Bone Stretch Refer toButtonhole Twin Needle Stitches Satin Stitch Acceptable resu Its 213 DarningDropping the Feed Dogs Set the MachineTopstitching On the zipper foot Sew in a ZipperOpenthezipper Monogramming Basic Zigzag Stitch width control 1 to Set the MachineWtu Chalk 234 Satin StitchStitch Length Control Sew 4 to 6 zigzag stitches Bar TackingFeed EmbroiderySee Sew a Button 0L\Zigzag foot Overcasting StitchControl 2 to 6Stitch length control red Blind Hemming Set the MachineFor LaceWork Set the Machine Stitch width Control 2 to 213 Zigzag foot Three-Step ZigzagStitch length Box StitchingShell Stitching Set the Machine Stitch width control 3 to Control 3 toFagoting Stitch Two-point Shell StitchOveredging Stitch Two-point Box StitchUseful to join elastic Stretch Stitch Decorate with Geometric PatternsSatin stitch FootStraight Stretch Zigzag foot Stitch and Its Uses Elastic Stretch Stitch Serging or Pine Leaf Stretch StitchingSet the Machine Stitch width control 3 to Stretch Patching Set the Machine Herring Bone StretchTop thread tension Decorative Stretch PatternsLength control Vests, jackets or coats #3tSlider Built-in System213-4 StitchSew 4 to 6 stitches Set the stitch selector at UStop sewing at the left stitch Will Using Buttonhole AttachmentTemplate 213504005 213505006 213506007 Sizes 15/16 More VariedStitch length control 3 to Optional Item Pins aLeave 3 to 4 inches of thread Optional ItemOptional Item Coarse stitches Satin stitch foot Set the Machine For any of these stitch Stitch widthIllustration a Upper Problem Probable CauseProblem Page Page Parts List Nuuou IruR 647814053 No Single Needles 647814020 No Single Needles647814031 No. !4 Single Needles 647814042 SingleBase plate Basic zigzag Storage box Additional Spool Pin Appliqueing Bar tackingZipper Foot 13, 26,3435,6667 3648Zigzag Overcasting Zipper 3435SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, IL Warranty385 SEARS, Roebuck and CO., Chicago, IL60684 U.S.A