Sears 385. 17928 owner manual Bobbin Winding

Page 19

•Bobbin Winding

f

f

Additional Spool Pin

IHorizontal Spool Pin

I

®

Pull the clutch knob away from the machine to disengage clutch.

(_ Draw the thread from the spool.

Guide the thread around the bobbin winder thread guide.

(_) Insert the thread through the hole in the bobbin, threading from the inside to the outside. _j Put the bobbin on the bobbin winding spindle, and push it to the right.

(_) With the free end of the thread held in your hand, depress the foot control.

(_ Stop the machine when it has made a few turns, and cut the thread close to the hole in the bobbin. Depress the foot control again. When the bobbin is fully wound, it will stop automatically.

(_) Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread as shown.

(_ Push in the clutch knobto engage clutch.

The machine will not sew until the clutch knob is pushed in.

F

17

Image 19

Contents

Sewing Machine SEARS, Roebuck and CO Important Safety Instructions Table of Contents Page ArmCoverPlate Page Safety Feature Plug in the Machine and Switch on the PowerSet the Pressure Dial Thread Cutter Adjust the Presser Foot LeverTo remove To AttachEtc Check the PresserFoot Change the Presser Foot PresserFoot TypesStitcing Sliding Buttonhole Foot Presser Foot TypesCheck the Needle Choose e Needle and ThreadTo Change the Needle Fabric, Needle, Thread and Stitch Length ChartOrdinary Spool Additional Spool PinFirmly against the thread spool To Remove the Bobbin from the Machine Horizontal Spool PinBobbin Winding So that Thread Insert the Bobbin into the Bobbin HolderThread the Needle Prepare the Top ThreadPick Up the Bobbin Thread III Adjust the Top Thread TensionTop tension Too Tight Too Loose Just Right For Zigzag StitchGuide messagewindow Rickrack stretch Reverse III Zigzag 3N5 38RedHerring Bone Stretch Refer toButtonhole Twin Needle Stitches Satin Stitch Acceptable resu Its 213 DarningDropping the Feed Dogs Set the MachineTopstitching On the zipper foot Sew in a ZipperOpenthezipper Monogramming Basic Zigzag Stitch width control 1 to Set the MachineWtu Chalk 234 Satin StitchStitch Length Control Sew 4 to 6 zigzag stitches Bar TackingFeed EmbroiderySee Sew a Button 0L\Zigzag foot Overcasting StitchControl 2 to 6Stitch length control red Blind Hemming Set the MachineFor LaceWork Set the Machine Stitch width Control 2 to 213 Zigzag foot Three-Step ZigzagStitch length Box StitchingShell Stitching Set the Machine Stitch width control 3 to Control 3 toFagoting Stitch Two-point Shell StitchOveredging Stitch Two-point Box StitchUseful to join elastic Stretch Stitch Decorate with Geometric PatternsSatin stitch FootStraight Stretch Zigzag foot Stitch and Its Uses Elastic Stretch Stitch Serging or Pine Leaf Stretch StitchingSet the Machine Stitch width control 3 to Stretch Patching Set the Machine Herring Bone StretchTop thread tension Decorative Stretch PatternsLength control Vests, jackets or coats #3tSlider Built-in System213-4 StitchSew 4 to 6 stitches Set the stitch selector at UStop sewing at the left stitch Will Using Buttonhole AttachmentTemplate 213504005 213505006 213506007 Sizes 15/16 More VariedStitch length control 3 to Optional Item Pins aLeave 3 to 4 inches of thread Optional ItemOptional Item Coarse stitches Satin stitch foot Set the Machine For any of these stitch Stitch widthIllustration a Upper Problem Probable CauseProblem Page Page Parts List Nuuou IruR 647814053 No Single Needles 647814020 No Single Needles647814031 No. !4 Single Needles 647814042 SingleBase plate Basic zigzag Storage box Additional Spool Pin Appliqueing Bar tackingZipper Foot 13, 26,3435,6667 3648Zigzag Overcasting Zipper 3435SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, IL Warranty385 SEARS, Roebuck and CO., Chicago, IL60684 U.S.A