Note:
The yarn must lie correctly between the two discs of the thread tension selector.
Thread tension selector q w
Thread routing on from the thread guide plate 8
further thread routing
3.Guide the yarn, as shown, from front to back through the eyes of the needles.
4.Pull the end of the thread about 10 cm (4“ ) out from the eyes of the needles. Lift the sewing foot o and slide the thread under it; then lower the sewing foot o back down. The lever for lifting and lowering the sewing foot o is located at the rear of the machine, above the sewing lever rod system.
Position the lever to lift the sewing foot o
Trial run
When yarn has been threaded for the first time, or after a yarn breakage it must be rethreaded, proceed as follows:
Lift the sewing foot o.
Hold the ends of the threads between the fingertips of your left hand, slowly turn the handwheel 6 two or three times towards yourself and then check the threads once again.
- 9 -