S H I E L D D O O R S • P E R F O R M A N C E U P G R A D E
D. Secure the jambs and head of the door. | EXTERIOR |
Drive #10 x |
|
wood screws through the door frame and |
|
shim, into the rough framing. Drive the |
|
screws until snug but DO NOT over- |
|
tighten the screws. DO NOT bend or |
|
bow the unit frame. |
|
| INTERIOR |
E.Drill 13/64” clearance holes through the threshold but not into the rough opening, at the locations shown in illustration on previous page (5E & 5G). Install #
10 x
NOTE: Not required on
Out-Swing
EXTERIOR
5C Drill 1/8” diameter pilot holes through the clearance
hole in the frame.
5D
#10 x | INTERIOR |
| |
corrosion resistant wood screw |
|
5D
HEAD
5E 5G
SILL
P E R F O R M A N C E U P G R A D E & H U R R I C A N E
Installation Clip Method:
F.Fasten the door to the opening by
driving two #8 x
block, install the screws as close to5F the bend as possible.
Note: DO NOT shim above the door. For masonry openings use two masonry screws that are a minimum size of 3/16” x
Frame Screw and Installation Clip Methods:
G.Drive #10 x
Note: For concrete floors, use masonry screws that are a minimum size of 3/16” diameter x 3”.