R S
Applications for Performance Upgrade and HurricaneShield:
P G R A D E & H U R R I C A N E S H I E L D D O O
Screw
Location
DIAGRAM FOR
PLACEMENT OF
THRESHOLD SCREWS &
INSTALLATION CLIPS
Screw
Location
| DOUBLE OPERABLE |
|
| SINGLE FIXED OR OPERABLE | ||||
|
| 2C |
|
|
|
| 2C |
|
|
| 6" |
|
|
|
|
|
|
6" | 16" MAX | 6" | 16" MAX | 6" |
| 6" | 16" MAX | 6" |
O.C. |
| O.C. |
| O.C. | ||||
|
|
|
|
|
| |||
6" |
|
|
|
| 6" | 6" |
| 6" |
2C |
|
|
|
| 2C | 2C |
| 2C |
16" |
|
|
|
| 16" | 16" |
| 16" |
MAX. |
|
|
|
| MAX. | MAX. |
| MAX. |
O.C. |
|
|
|
| O.C. | O.C. |
| O.C. |
6" |
|
|
|
| 6" | 6" |
| 6" |
6" | 16" MAX | 6" 6" | 16" MAX | 6" |
| 6" | 16" MAX | 6" |
O.C. | O.C. |
| O.C. | |||||
|
| 5E |
|
|
|
| 5E |
|
P E R F O R M A N C E U
C.Doors using Installation Clips: Install installation clips. Place each clip so the lip is facing up and against the installation fin at the locations shown in the placement diagram. Secure each clip by driving a #6 x 5/8” corrosion resistant screw through each of the outer two holes of the three holes shown.
Note: If clips are to be bent;
#6 x 5/8” corrosion resistant screws
Lip
2C
6“ from end
A L L D O O R S • A L L D O O R S
3 | SETTING AND |
|
FASTENING | 6” | |
|
| |
| THE DOOR |
|
A.Place three 3/8” beads of sealant.
Place the first beads sealant ½” from
the base of the interior sill pan lip.3rd Bead This bead should also continue up the
corner of the sill pan at each end, sealing the vertical
joints of the sill pan legs. Continue the first bead up 6” onto each jamb side of the rough opening. The second bead should be approximately ½” from the exterior edge of the rough opening, running from
jamb to jamb with a 2” break in the middle of the
opening. Place a third sealant bead in the groove
of the sill support from end to end or ¼” from the
exterior edge of the wood blocking.
Note: Sill sealant detail is the same for applications with and without optional sill pan.
1st Bead |
| 3A | |
2nd Bead |
| ||
|
| ||
| Leave a 2" break | ||
INTERIOR | in | center of pan | |
SILL | |||
| |||
| PAN LIP |
|
6” | 3A |
1 |
|
2 |
|
3 |
|
Applications without sill pan