Hampton Bay H200 installation manual Residential Installation, Modular Installation Options

Page 8

INSTALLATION

RESIDENTIAL

INSTALLATION

1)Please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even death. Be aware that local Codes and Regulations may override some items in this manual. Check with your local inspector.

2)Select a position for your Hampton Stove. Consult the minimum clearance chart for your model and set the stove in place. For close clearance installation use listed double wall connector systems.

3)To insure vertical alignment, suspend a plumb bob from the ceiling over the exact center of your stove flue and mark a spot on the ceiling to indicate the center of the chimney.

4)Check that the area above the ceiling is clear for cutting. Re-confirm the clearance from the stove to combustibles to insure that they are within the prescribed limits.

5)This woodstove must be connected to a UL 103 HT (ULC S629) listed chimney or a code approved masonry chimney with a flue liner, from the ceiling and beyond.

6)Install chimney according to chimney manu- facturers instructions. The performance of your woodstove is governed to a very large part by the chimney system. Too short a chimney can cause difficult start-up, dirty glass, backsmoking when door is open, and

even reduced heat output. Too tall a chimney may prompt excessive draft which can result in very short burn times and excessive heat output. The use of an inexpensive flue pipe damper may be helpful in reducing excessive draft.

CAUTION: The chimney should be the same size as the 6" (152mm) flue outlet on the stove. The chimney must be listed as suit- able for use with solid fuels. For other types of chimneys check with your local building code officials. Do not confuse a chimney with a type “B” Venting System used for gas appliances as suitable for a wood burning appliance (refer to the Mobile Home instal- lations section).

7)Mark the location of the legs on the floor, then move the stove aside and mark the position of the floor protector.

8)The floor protector must be of non-combus- tible material and must extend 16" (406mm) in front of the door opening and 6" (152mm) to the sides and rear of the unit. Some areas may require a larger size floor protector. However, when installing the unit with the short leg option there is a requirement of 0.84k of floor protector beneath the non- combustible finished floor. See your local inspector. For outside air installation (refer to Mobile Home installation section).

NOTE: In Canada, floor protection must ex- tend 18" (450mm) to the front and 8" (200mm) to each side and back of the stove.

9)When the floor protection is complete, posi- tion the stove with the flue collar centered under the installed chimney.

10)In seismically active areas, we recommend that your unit is secured to the floor by using the bolt down holes inside the legs (the same ones used in Mobile Home installations).

11)For residential installations using 6" (152mm) "C" Vent (single wall) the chimney connector must be at least 24 gauge steel. Do not use galvanized pipe (refer to the Mobile Home installation section).

12)Do not connect this unit to a chimney serving another appliance.

13)A chimney connector cannot pass through an attic or roof space, closet or similar concealed space, or a floor, ceiling, wall or partition of combustible construction. In Canada, if passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365, Installation Code for Solid- Fuel-Burning Appliances and Equipment.

14)Your Hampton Woodstove is not to be con- nected to any air distribution duct.

Emissions from burning wood or gas could contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

MODULAR INSTALLATION OPTIONS

OPTIONS: These can be installed at time of installation or added later:

Modular Option

Things to consider when choosing options

Blower/Fan

Adding the blower will increase the area heated by the stove, it can move warm air beyond the room where the stove

is installed (refer to the Optional Blower / Fan Installation section).

 

 

Outside Air

Helps combustion in small or poorly ventilated houses. Installation instructions come with adaptor.

Adaptor

 

 

Side Shelves

Add to the traditional look of the stove and double as a warming area for your cookstove creations.

 

 

Ash Drawer

Adding the ash drawer will allow for easier removal and transport of ashes.

 

 

Short Legs

Helps in reducing the overall height of the unit to accomodate a variety of installations. Using this option prohibits the

 

use of the ash drawer.

8

Hampton H200 Cast Freestanding Woodstove

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Freestanding Woodstove Hampton Fireplace Product Table of Contents Safety Label 290Installation Unit Dimensions with Standard LegsUnit Dimensions with Optional Short Legs Rotating Elbow PRE-INSTALLATION AssemblyDraft Control Lever Handle Residential Installation Modular Installation OptionsResidential Installation C Vent Single Wall Minimum Clearance to Combustible MaterialsMinimum Alcove Clearance to Combustible Materials Additional Clearances For Backwall ExitMinimum Clearance to Combustibles Minimum Clearance to Non-CombustiblesFloor Protection Step bSTEP-BY-STEP Chimney Connector Installation Factory Built ChimneyMasonry Chimney Masonry FireplaceCombustible Wall Chimney Connector PASS-THROUGHS Method a 12 304.8 mm Clearance to Combustible Wall MemberRecommended Heights for Woodstove Flue Example bMobile Home Installation Canadian Installations Listed Components For Mobile Home InstallationInstallation Door Removal Brick InstallationOptional Short LEG Installation Optional BLOWER/FAN Installation Back ShieldOptional Side Shelf Installation Underside of Side Shelf ShownOptional ASH Drawer KIT Installation Andiron BricksOperating Instructions Operating InstructionsFAN Operation First FireSafety Guidelines Draft ControlOptional Ash Drawer Operating Guideline Safety PrecautionsASH Disposal Maintenance Handle Replacement Latch Adjustment MethodBe changed after adjustment Front Door GasketTOP Baffle Replacement Parts List H200 Main AssemblyParts List H200 Door Assembly PART# DescriptionH200 ASH Drawer Assembly H200 FAN Assembly 910-157 FAN ThermodiscHampton H200 Cast Freestanding Woodstove Hampton H200 Cast Freestanding Woodstove Warranty ConditionsInstaller Please complete the following information

H200 specifications

The Hampton Bay H200 is a standout model in the realm of outdoor heating solutions, providing both comfort and style for outdoor spaces. As homeowners increasingly seek to extend their enjoyment of patios and backyards, the H200 delivers with an impressive range of features, cutting-edge technologies, and thoughtful design characteristics.

One of the key features of the Hampton Bay H200 is its powerful heating capability. Equipped with a high-efficiency burner, it generates a substantial amount of heat, making it suitable for use on chilly evenings. With an adjustable heat setting, users can easily customize the temperature to suit their comfort level and specific outdoor conditions.

The H200 is also designed with energy efficiency in mind. Its innovative burner technology ensures that it utilizes fuel efficiently, allowing for longer usage times without frequent refueling. This not only saves on operational costs but also reduces the environmental impact associated with outdoor heating.

Portability is another prominent characteristic of the H200. It features a lightweight construction with easy-to-move wheels, enabling users to relocate the heater effortlessly. Whether moving it closer to a gathering or storing it away during warmer months, the H200 makes it convenient to adapt to changing outdoor needs.

Durability is crucial in any outdoor appliance, and the Hampton Bay H200 does not disappoint. Constructed from high-quality materials, it is built to withstand the elements, ensuring longevity and reliable performance. The sleek and modern design with a weather-resistant finish not only enhances its durability but also adds an attractive aesthetic to any outdoor setting.

Safety is a top priority for outdoor heating equipment, and the H200 is equipped with several safety features that provide peace of mind. The automatic shut-off function activates if the heater is tipped over, helping to prevent accidents. Additionally, the safety grid protects users from direct contact with the hot surfaces, reducing the risk of burns.

In summary, the Hampton Bay H200 is a formidable option for anyone looking to enhance their outdoor space. With its powerful heating capabilities, energy-efficient burner technology, portability, durability, and robust safety features, it is well-equipped to offer warmth and comfort in any outdoor environment. Its stylish design seamlessly integrates into various outdoor aesthetics, making it a versatile choice for patios, decks, and gardens alike.
Top Page Image Contents