England's Stove Works 55-TRP22E operation manual Daily Operation

Page 11

DAILY OPERATION

Refueling the Unit

Always press the “OFF” touch pad before refueling. This stove has a (approximately) 60-lb. hopper, and should be refilled when the hopper level drops to three or four inches.

Note: The hopper lid will be warm; therefore, you should always use some type of hand protection. NEVER place your hand near the auger while the stove is operating.

Note: Always ensure that all pellet matter is cleared from the hopper lid gasket before closing. Be sure to close and latch hopper securely before re-firing. Do not operate this unit with the hopper lid open or unsecured.

Power Outage

If the power to the unit is interrupted for approximately three minutes or less, the unit will resume operation when power is restored according to the following table:

Unit’s State Before Power Loss

State When Power Returns

ON

Start-Up

Start-Up

Start-Up

Shut-Down

Shut-Down

OFF

OFF

If the power is interrupted for more than (approximately) three minutes, the unit will be “OFF” when power returns.

Important: Do NOT open the hopper lid or the door to the unit during power outage. Open the closest outside door and a window to eliminate the home’s natural draft.

Wait for power to be restored and then press the “ON” button to re-start the unit, if necessary. We highly recommend the use of a surge protector with your unit, as power surges and failures

can affect the operation of any electrical appliance.

We do not recommend leaving home with the stove on the higher heat ranges; it is recommended that the stove be left on the lower heat ranges (Heat Range setting 1 or 2).

NOTE: Remember: 1) It is very important for the unit to be vented properly (see instructions on Outside Air), as the natural draft is needed to clear the smoke from the stove. 2) Do not open the hopper lid (or the unit’s door). This may cause fire to burn in the hopper.

Fuel Outage

If the unit should run out of pellets, simply reload the hopper and press the “ON” button (only once) to re-start the unit. If the unit runs without pellets, after one hour the unit will shut down. NOTE: Even if flames are visible inside the fire box always press the “ON” button to ensure that your unit will restart.

Combustion Blower Failure

If the Combustion (exhaust) Blower should fail on this unit, a Vacuum Shut-Down Switch will automatically stop the stove. This will shut your unit completely off, and there will be an “E-1” code in the Heat Range and Blower Speed windows on the Control Board. At this point you will need to contact Technical Support at (800) 245-6489.

NOTE: It is very important for the unit to be vented properly (see instructions on Outside Air), as the natural draft is needed to clear the smoke from the stove.

11

Image 11
Contents Be maintained Model NumbersLetter from our Technical Support department Important Information Unit Preparation Questions, parts/accessory orders and more Through the Wall Flue SystemPellet Vent Pipe Outside Air Outside Combustion Air Intake Mobile Home InstallationThrough the Ceiling Existing Flue SystemWall Protection Floor and Wall ProtectionFloor Protection Manually Starting Your Unit Operating InstructionsHorizontal Feed System Codes SHUT-DOWN ProcedureDaily Operation Semi-Weekly Ash Removal ASH Removal and DisposalMonthly Ash Removal Annual CleaningAuger Bearings and Auger Shafts MaintenanceRear Panel Removal Auger MotorsGaskets Vacuum SwitchConvection Blower Combustion BlowerRecommended Heat Ranges Control BoardIllustration 2b Control Board Diagram Wiring Adjusting your Hopper Lid Latches AC-106-P SH-106-P, AC-106-PBN Window Trim ThermostatsAC-103, AC-103BN Lip Trim Box Parts Orders only Monroe, VA Questions 800-245-6489 Fax Replacement PARTS, Accessories and OptionsTechnical Support Department Pellet Stove Exploded View Diagram Problem Cause Solution TROUBLE-SHOOTING GuideWarranty is not Transferable Page Warranty Registration for England’s Stove Works
Related manuals
Manual 24 pages 43.38 Kb