England's Stove Works 55-TRP22E operation manual Thermostats, AC-103, AC-103BN Lip Trim

Page 19

ACCESSORY ITEMS

The following accessories can be added to your unit at anytime after purchase; however, let the unit cool down before adding any accessories.

Thermostats

WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on our pellet units as long as it is a low-voltage that works with millivolt systems. After unplugging the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two screws should then be loosened and the jumper wire removed from the board. Next, the two thermostat lead wires should be slipped into these openings and the screws tightened; the jumper wire should be saved for future operation without a thermostat.

The unit will operate differently once the wall thermostat is connected – we recommend the Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.

AC-103, AC-103BN Lip Trim

There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the stove. Match the channel with the correct edge of the ash apron, then remove the protective covering from the trim and force the piece onto the edge. Although it should stay in place, stove cement can be used to secure it if necessary.

NOTE: For stoves manufactured prior to 2001, the part number for this kit is AC-101-PU.

AC-106-P (SH-106-P), AC-106-PBN Window Trim

This trim can be attached by using the provided spring clip and some high temperature silicone. Insert the tee end of the spring clip into the opening on the edge of the trim – this will allow the clip to fall into the groove. The spring clip will hold well if it is placed on the bottom edge of the trim. We also suggest that high temperature silicone be used on the corners, to ensure the trim will stay in place.

Accessories can be ordered from the factory at:

(Parts orders ONLY) -- (800) 516-3636, or on our web site: www.englanderstoves.com.

Questions/Problems: Please call Technical Support at (800) 245-6489.

You may also order parts and options, view frequently asked questions and more,

on our web site: www.englanderstoves.com

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Be maintained Model NumbersLetter from our Technical Support department Important Information Unit Preparation Questions, parts/accessory orders and more Pellet Vent Pipe Flue SystemThrough the Wall Outside Air Outside Combustion Air Intake Mobile Home InstallationThrough the Ceiling Existing Flue SystemFloor Protection Floor and Wall ProtectionWall Protection Horizontal Feed System Operating InstructionsManually Starting Your Unit Codes SHUT-DOWN ProcedureDaily Operation Semi-Weekly Ash Removal ASH Removal and DisposalMonthly Ash Removal Annual CleaningAuger Bearings and Auger Shafts MaintenanceRear Panel Removal Auger MotorsGaskets Vacuum SwitchConvection Blower Combustion BlowerRecommended Heat Ranges Control BoardIllustration 2b Control Board Diagram Wiring Adjusting your Hopper Lid Latches AC-103, AC-103BN Lip Trim ThermostatsAC-106-P SH-106-P, AC-106-PBN Window Trim Technical Support Department Replacement PARTS, Accessories and OptionsBox Parts Orders only Monroe, VA Questions 800-245-6489 Fax Pellet Stove Exploded View Diagram Problem Cause Solution TROUBLE-SHOOTING GuideWarranty is not Transferable Page Warranty Registration for England’s Stove Works
Related manuals
Manual 24 pages 43.38 Kb
Top Page Image Contents