Enviro 1700 Fireplace Insert, C-10240, 1700 Freestanding, 1200 Fireplace Insert, 50-1040 Outside AIR

Page 27

Installation

These connectors must be installed in accordance with the manufacturer’s instructions. Use only specified components. The chimney and pipe must extend at least 10 feet (2.4 m) above the stove and 3 feet (0.9 m) above the highest point of the roof. Install a rain cap with spark arrestor at the top that will not impede the smoke exhaust. The chimney must be supported at the ceiling or roof so that its weight will not sit on the stove. Seal with silicone to maintain vapor barrier at the chimney and outside air penetrations.

CAUTION: THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.

OUTSIDE AIR :

Connection from the stoves air intake to the outside is mandatory, (MOBILE HOMES ONLY) either through a hole in the wall not higher than the stoves bottom or through a hole in the floor beneath the pedestal, using the fresh air adaptor provided. If the air intake is through the floor, the hole in the pedestal back must be closed with the sheet metal cover provided. Avoid cutting any floor joists, wall studs, electrical wiring or plumbing. Seal around the outside air pipe with insulation to prevent drafts. Also install a 1⁄4” mesh rodent or pest screen in the end of fresh-air pipe. Fresh-air connection must be of a non-combustible material, example: 4” (10.16 cm) flexible aluminum single wall pipe.

Fresh air could also be supplied from a vented crawlspace.

 

Spark arrestor cap

At least

Roof flashing

3 feet (914 mm)

Roof

 

Insulated

Radiation Shield

chimney

 

Ceiling

Ceiling support

 

 

Double wall pipe

 

Woodstove

Optional

 

fan

 

 

Pedestal

 

Hearthpad

Outside air connection

Floor

through wall or floor

Bolt stove to floor

Figure 28: Freestanding installation into mobile home.

The pedestal must be firmly bolted to the floor using two (2) 1⁄4” bolts. Be sure to replace any insulation or panels removed when fastening the bottom nuts.

If room air starvation occurs because the air intake is blocked with ice, leaves etc. or because the stove door was left open, or due to a strong exhaust fan operating, dangerous fumes could be sucked into the room.

IN SOME AREAS IT MAY BE REQUIRED TO ELECTRICALLY GROUND THE STOVE TO THE STEEL CHASSIS OF THE MOBILE HOME.

When this unit is installed in a Mobile Home it must be grounded to the steel chassis or connected to a grounding rod.

Manufactured (Mobile) home installation must be in accordance with the Manufactured Home Construction and Safety Standard, UL 307B, Title 24 CFR, Part 3280 and/or The Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A.

WARNING: DO NOT INSTALL IN A MOBILE HOME SLEEPING ROOM.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Wood Stove Table of Contents Safety Precautions First Start Operating InstructionsCreosote ITS Formation and Removal Helpful Hints Worth Repeating What type of wood is best to use as firewood? What can cause a poor draft? 1200 Air Flow Path Specifications Capacity Feet3 0.0708 meter3 Approximate heating area † From front of unit to edge of floor protection Maintain These Minimum Clearances to Unshielded Combustibles 1700 Freestanding Clearance to Combustibles 1200 Insert Dimensions 1200 Freestanding Flat Top Dimensions 1700 Freestanding Flat Top Dimensions 1200 Freestanding with Fan Kit Dimensions Bolts to remove InstallationInstalling Heat Shield Recommended Height for Flue Pipe Chimney Through Wall Method a Roof Clearances Shield if required Installation into a masonry chimney Venting Outside AIR Insert Installation into existing fireplace With hearth Attaching removable flue Total Bricks Model 1700 Brick Placement Do not USE Door if Glass is Broken Installation of Ceramic Baffle Back View of Freestanding Unit with Fan Kit Removal of right pod This will keep the trim tight Parts List Parts List Parts Diagram Parts Diagram Pedestals & Legs Parts Diagram Fireplace Insert Limited Five 5 Year Warranty Limited One 1 Year Warranty WarrantyExclusions and Limitations Warranty Installation Data Sheet

1200 Fireplace Insert, 50-1040, 1200 Freestanding, 1700 Fireplace Insert, C-10240 specifications

The Enviro 1700 Freestanding, C-10240, 1700 Fireplace Insert, and 1200 Freestanding models are exceptional choices for those seeking both aesthetic appeal and efficient heating performance. These fireplaces combine advanced technology with modern design, making them suitable for various home styles while providing effective warmth.

One of the standout features of the Enviro 1700 Freestanding unit is its elegant design. Its clean lines and contemporary look allow it to blend seamlessly into any room. The fireplace is constructed from high-quality materials, ensuring durability and longevity. This model is designed to produce maximum heat output while minimizing wood consumption, making it an eco-friendly option.

The C-10240 model, designed for those who prefer a traditional fireplace insert, showcases a unique combination of classic design with innovative technology. This insert provides the warmth and ambiance of a classic wood-burning fire without compromising efficiency. It is equipped with a powerful combustion system that ensures a clean burn, reducing emissions and providing a sustainable heating solution for homes.

The 1700 Fireplace Insert model is perfect for homeowners looking for an effective way to upgrade their existing fireplace. This insert offers the benefits of modern heating technology while maintaining the charm of a traditional fireplace. It features an expansive viewing area, allowing for an impressive display of flames and creating a cozy atmosphere. Its robust design ensures that it fits snugly into existing hearths, providing an instant upgrade.

The 1200 Freestanding model is designed for versatility. Whether placed in the center of a room or in a corner, it offers a 360-degree view of the fire. This model utilizes advanced clean-burning technology, ensuring that the fire produces minimal smoke and pollutants. Its efficient heat distribution system allows for optimal warmth, making it an excellent choice for heating larger spaces.

All these models feature advanced air wash systems that keep the glass door clean for unobstructed views of the flames. Additional options, such as direct venting and multi-fuel capabilities, further enhance their flexibility and performance. Whether you opt for the 1700 Freestanding, C-10240, 1700 Fireplace Insert, or the 1200 Freestanding, you can be assured of reliable heat, stunning views, and environmentally friendly operation throughout the colder months.
Top Page Image Contents