Introduction

SOOT: Operation of the stove with insufficient combustion air will result in the formation of soot which will collect on the glass, the heat exchanger, the exhaust vent system, and may stain the outside of the house. This is a dangerous situation and is inefficient. Frequently check your stove and adjust the slider/ damper as needed to ensure proper combustion.

Electrical: THE USE OF A SURGE PROTECTED POWER BAR IS RECOMMENDED. The maximum power requirement is 800 watts (3.3 amp). The stove has a grounded electrical cord and should be connected to a standard 220-240 volt, 50 Hz grounded electrical outlet. Make sure the electrical cord is not trapped under the appliance and that it is clear of any hot surfaces or sharp edges. When installing the stove in a mobile home, it must be electrically grounded to the steel chassis of the home and bolted to the floor in accordance with applicable local, state or federal codes.

GLASS: Do not abuse the glass by striking or slamming the door. Do not attempt to operate the stove with broken glass. The stove uses ceramic glass. Replacement glass must be purchased from an ENVIRO dealer. Do not attempt to open the door and clean the glass while the unit is in operation or if glass is hot. To clean the glass, use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner, or take a damp paper towel and dip into the fly ash. This is a very mild abrasive and will not damage the glass.

FLAMMABLE LIQUIDS: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in the heater. Keep all such liquids well away from the heater while it is in use.

SMOKE DETECTOR: Smoke detectors should be installed and maintained in the structure when installing and operating a pellet burning appliance.

OPERATION: The ash pan and door must be closed securely for proper and safe operation of the pellet stove. Also ensure all gaskets on the door are checked and replaced when necessary.

INSTALLATION: Be sure to maintain the structural integrity of your home when passing a vent through walls, ceilings, or roofs. It is recommended that the unit be secured into its position in order to avoid any displacement.

DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.

FRESH AIR: Outside Fresh Air connection is optional. Must be connected to all units installed in Mobile and “Air Tight Homes” (R2000) or where required by local codes. Consider all large air moving devices when installing your unit and provide room air accordingly. Limited air for combustion may result in poor performance, smoking and other side effects of poor combustion.

If you have any questions with regards to your stove or the above-mentioned information, please feel free to contact your local dealer for further clarification and comments.

SINCE SHERWOOD INDUSTRIES LTD. HAS NO CONTROL OVER THE INSTALLATION OF YOUR STOVE, SHERWOOD INDUSTRIES LTD. GRANTS NO WARRANTY IMPLIED OR STATED FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE. THEREFORE, SHERWOOD INDUSTRIES LTD. ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).

SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

EF THERMO 28 specifications

The Enviro EF THERMO 28 is a cutting-edge multifuel stove that exemplifies efficient heating and contemporary design, making it an attractive option for homeowners seeking both functionality and aesthetics. This stove is engineered to optimize performance while reducing environmental impact, aligning with today’s energy-conscious lifestyles.

One of the standout features of the EF THERMO 28 is its impressive efficiency rating. It boasts an efficiency level of over 80%, ensuring that a significant portion of the fuel burned is converted into usable heat. This high efficiency minimizes fuel consumption, making it not only cost-effective but also environmentally friendly by decreasing emissions.

The stove is designed to burn a wide range of fuels, including wood, pellets, and even coal, providing users with flexibility depending on their heating needs and fuel availability. The advanced combustion system employed in the EF THERMO 28 utilizes secondary air injection, which promotes a cleaner burn and enhances overall heating performance. This technology not only contributes to lower emissions but also ensures that the stove operates effectively even in varying conditions.

Another notable characteristic of the EF THERMO 28 is its robust construction. Built from high-quality steel and equipped with a ceramic glass door, the stove is designed to withstand high temperatures while maintaining safety and durability. The design also features a large viewing window, allowing for an inviting aesthetic appeal as flames dance within the firebox.

The stove’s intuitive control system is user-friendly, featuring an adjustable air control that allows users to fine-tune the burn rate for optimal heat output. This enables more precise heating management, enhancing comfort in the home while also conserving fuel. Additionally, its compact size makes it suitable for various spaces, whether it be a rustic cabin or a modern home.

Overall, the Enviro EF THERMO 28 represents a blend of innovation, efficiency, and style. With its multifuel capabilities, high efficiency, advanced combustion technologies, and user-friendly features, this stove is an ideal choice for those looking to enhance their heating experience while adhering to eco-friendly practices. Whether for primary heating or supplementary warmth, the EF THERMO 28 provides an effective solution that caters to diverse preferences and needs in home heating.