Harman Stove Company P68 owner manual Venting, Addition, the following must be observed

Page 7

Venting

Requirements for Terminating the Venting WARNING: Venting terminals must not be re-

cessed into a wall or siding.

NOTE: Only PL vent pipe wall pass-throughs and fire stops should be used when venting through combustible materials.

NOTE: Always take into consideration the ef- fects of the prevailing wind direction or other wind currents that may cause flyash and/or smoke when placing the termination vent.

In addition, the following must be observed:

A. The clearance above grade must be a mini- mum of 18".1

B. The clearance to a window or door that may be opened must be a minimum of 48" to the side, 48" below the window/door, and 12" above the win- dow/door.1

( with outside air installed, 18” )

C. A 12" clearance to a permanently closed window is recommended to prevent condensation on the window.

D. The vertical clearance to a ventilated soffit located above the terminal within a horizontal dis- tance of 2 feet (60 cm) from the center-line of the terminal must be a minimum of 18".

E. The clearance to an unventilated soffit must be a minimum of 12".

F. The clearance to an outside corner is 11" from center of pipe.

G. The clearance to an inside corner is 12".

H.A vent must not be installed within 3 feet (90 cm) above a gas meter/regulator assembly when measured from the horizontal center-line of the regu- lator.1

I. The clearance to service regulator vent outlet must be a minimum of 6 feet.1

J. The clearance to a non-mechanical air sup-

ply inlet to the building or the combustion air inlet to any other appliance must be a minimum of 48”.1

K. The clearance to a mechanical air supply inlet must be a minimum of 10 feet.1

(with outside air installed, 6 feet )

L. The clearance above a paved sidewalk or a paved driveway located on public property must be a minimum of 7 feet.1,2

M. The clearance under a veranda, porch, deck or balcony must be a minimum of 12 inches.1,3

NOTE: The clearance to vegetation and other exterior combustibles such as mulch is 36” as mea- sured from the center of the outlet or cap. This 36”

radius continues to grade or a minimum of 7 feet below the outlet.

1Certain Canadian and or Local codes or regu- lations may require different clearances.

2A vent shall not terminate directly above a side- walk or paved driveway which is located between two single family dwellings and serves both dwell- ings.

3Only permitted if veranda, porch, deck, or bal- cony is fully open on a minimum of 2 sides beneath the floor.

NOTE: Where passage through a wall, or partition of combustible construction is desired, the installation shall conformto CAN/CSA-B365. (if in Canada)

Inside Corner

Detail

Fixed

 

 

Closed

Openable

Fixed

Openable

 

Closed

 

 

V

= Vent terminal

A = Air supply inlet

= Area where terminal is not permitted

P68 Pellet Stove 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Safety Notice Installation & Operating ManualP68 Pellet Stove Introduction Table of ContentsImportant Notes Door Handle Installation Assembly and InstallationInstalling InstallationAddition, the following must be observed With outside air installedWith outside air installed, 6 feet VentingVent Pipe VentingHRV Outside Air#2 Preferred method #1 Preferred methodThroughs #5 Installing into an existing fireplace chimney US only #4 Installing into an existing chimney US only#7 Installing into an existing chimney US and Canada #8 Installing through the ceiling Minimum flue vent configurationP68 Automatic IGNITION/OPERATION Room Temperature ModeFeed Adjuster Knob Stove Temperature Mode Shut Down ProcedureP68 Automatic Start UP Igniter Switch toAUTOup positionTurn Mode Selector to OFF Turn Feed Adjuster to #4.4Stove Temperature Mode Room Temperature ModeP68 Manual IGNITION/OPERATION P68 Manual Start UP Igniter Switch toMANUAL down positionFill hopper with pellets and remove ashes as required.1 P68 Automatic Ignition ESP Control Status light error messagesLow Draft Voltage Adjustment P68 Low Draft Voltage AdjustmentRoom Sensor Installation Room Sensor and Rear Shield InstallationRear Shields Removing Ashes MaintenanceCleaning the Door Glass CleaningSoot and FlyAsh Cause a House FireBurn Pot Cleaning and Maintenance P68 Maintenance Burn PotP68 Maintenance Gasket Adjustment P68 Maintenance Cleaning the Feeder Body Cleaning Burn Pot P68 Trouble-ShootingSpecifications P68 Feeder and SpecificationsHopper Extension OptionsSide Heat Shields Floor ProtectorP68 Wiring Diagram Description Part Number P68 Parts ListYear Limited Warranty Commercial Harman Gold Warranty

P68 specifications

The Harman Stove Company P68 is a high-efficiency pellet stove that stands out for its blend of advanced technology and user-friendly features. Designed for both comfort and convenience, the P68 offers a remarkable heating capacity while maintaining an appealing aesthetic that fits well with a variety of home interiors.

One of the key features of the P68 is its impressive heating capability. With the ability to produce up to 68,000 BTUs, this stove can effectively heat spaces of up to 3,800 square feet. This makes it an excellent choice for both residential and larger commercial environments. The P68’s large hopper capacity, capable of holding up to 68 pounds of pellets, allows for extended burn times, providing homeowners with less frequent refueling.

The stove is equipped with Harman’s patented Smart Control technology, which optimizes fuel efficiency and heat output. This intelligent control system continuously monitors the burn rate and adjusts the feed rate of pellets accordingly. This ensures a consistent and comfortable temperature while minimizing waste. Users can also take advantage of the intuitive digital control panel, which allows for easy temperature adjustments and programming options.

In terms of design, the P68 is as functional as it is stylish. It features a large viewing window, allowing users to enjoy the beauty of the flames and create a cozy atmosphere. The stove is also available in multiple color finishes, ensuring it can complement any home decor.

Another standout characteristic of the P68 is its ease of maintenance. The design includes a removable ash pan for quick and straightforward cleaning. Furthermore, the patented burn pot design minimizes clinkers, reducing the need for frequent maintenance.

The Harman Stove Company P68 also emphasizes safety with its built-in safety features, including a pressure switch that monitors venting blockages, ensuring safe operation. With its combination of high efficiency, advanced technology, and user-friendly design, the P68 is an excellent choice for anyone looking to enhance their home heating system while prioritizing both comfort and style. Whether for a chilly winter evening or a cozy family gathering, the Harman P68 continues to be a superior option for pellet heating solutions.
Top Page Image Contents