Harman Stove Company 2 manual Maintenance Burn Pot, Burn Pot Cleaning and Maintenance

Maintenance - Burn Pot 22

Fig. 39

Fig. 40

Fig. 41

Burn Pot Cleaning and Maintenance

1.Scrape the top holed surface and sides of the burn pot down to auger tube.(Fig 39) It is not necessary to completely remove all material from the burn pot. The excess will be pushed out during the next use.

2.Loosen the (2) wing thumb screws on the lower front angle of the burn pot. (Fig. 40)

3.Lift off the clean-out cover (Fig.40) to open the bottom clean-out chamber. (Fig.41)

DANGER

Disconnect the power to the unit before

removing cover.

4.Clean ash buildup from inside the chamber while cover is off. Use the scraper to tap on the top front edge of the burn pot. This will help knock pieces of ash, loosened by the scraping process, down through the holes. It also helps knock scale off of the ignitor element.

Figure 41

The ignitor is made to be removable for service by insulated male/female wire connectors. These connections between the hot leads (the wires inside the burn pot) and the cold leads (the wires from the control board) are always pulled to the inside rear of the feeder body. (Not coiled inside the burn pot.)

It is very important that these connections are to the inside rear of the feeder body. Also, the extra wire of the ignitor wire service loop must be pulled out through the rear of the feeder and tied up so that it will not be damaged by any moving parts. See page 24.

Burn pot igniter	DANGER
	Disconnect the power to the unit before
	removing cover.

WARNING

Use caution when cleaning burn pot clean-

out chamber. Do not damage the high

temperature igniter wires.

Igniter hot lead wires (high temperature)

Note: The hot lead/cold lead connection must always be pulled to the rear of the feeder body before operation.

Viewed from below through the ash pan opening.