Harman Stove Company 2 manual Automatic Start Up, Starting First Fire

Automatic Start Up 4

Fig. 3	See Note 7.
	1"

Fig. 4

1.Fines are small pieces of broken pellets (sawdust). Fines do not flow easily and often build up on the hopper funnel bottom angles. These fines can be pushed into the feeder opening and then fill the hopper with pellets. As the system works, they will be burned.

2.The "TEST" cycle will operate the feeder motor for exactly one minute. Turning to "TEST" again and again may purge too much fuel into the burn pot causing excessive smoke on start- up.

3.The firebox low pressure switch will not allow the auger motor or the igniter element to operate if the view door is open.

4.Adjust Feed Rate. If this is your first fire or you are trying different pellets, set the feed adjuster to #4, Fig. 3. This is a conservative number and will probably need to be increased. After you know a feed rate setting that works well, use that setting. Remember, if your feed rate is too high you may waste fuel.

5.This is usually a weekly maintence procedure. Cleaning the burn pot with the scraper with a small amount of new fuel in the bottom is not a problem. First, scrape the ashes on the front of the burn pot into the ash pan. Then scrape the holed surface downward into the burn pot. When the stove is ignited these scrapings will be pushed out by the feeder.

6.The ash pan can hold the ashes from approximately 1 ton of premium fuel. This means the ashes will only need to be emptied a few times a year.

7.Setting the feed adjuster # for maximum burn: With the unit burning in "AUTO", turn to "Stove Mode" and put the fan on "H". Set the Temperature Dial to #7.Allow the unit to burn for about

30minutes and check ash on front of burn pot. Fig. 4. If the ash line is larger than 1", turn the feed adjuster from #4 to #5. Allow another 30 minutes of burn time and check again. If , at #6 setting, a 1" or less ash bed is not obtainable, it is not a problem. The 1" ash bed is only a maximum burn rate and at most normal settings the ash bed will be larger.

Starting First Fire

Ignitor Switch to"AUTO" (down position)

Make sure the unit is plugged into a 120 VAC, 60 HZ electrical source. The power light should be the only light lit.

1.Turn Mode Selector to "OFF".

2.Fill hopperwith pellets.1

3.Clean burn potwith scraper, if necessary.5

4.If starting after an empty hopper, turn Feed Adjuster to "TEST" (for one 60 second cycle).2

This will purge pellets into the auger tube and also allow you to check the motors for operation.NOTE:

The auger motor will not operate with the view door or ash pan door open.3

5.Turn Feed Adjuster to #4.4

6.Flip the Ignitor Switch downinto the "AUTO" position.

7.Turn the Temperature Dial to desired room temperature.

8.Turn Mode Selector to Room Temperature or Stove Temperature.

9.Fill hopper with pellets and remove ashes as required.6

Notice when using Optional Battery Back-Up:

If a power outage is expected, change the toggle switch to Manual Mode. The Harman 502H Battery Backup is incapable of powering the igniter. If an automatic ignition is attempted while the stoves is being powered by the battery back up, it may cause damage to both the stove and the battery backup unit.

Warning

NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMILAR LIQUIDS TO START OR 'FRESHEN UP' A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IN USE.