3Com 3CR990 Removing, Double-click the Add/Remove Programs icon in the Control Panel, Technology

82APPENDIX F: DYNAMICACCESS TECHNOLOGY

Follow this procedure to configure DynamicAccess technology on a local PC:

1Double-click the 3Com DynamicAccess icon in the Windows Control Panel.

The Traffic Prioritization tab of the DynamicAccess Software Setup screen appears.

2Select the tab containing the information that you want to configure.

■Traffic Prioritization—Allows you to prioritize applications, which can ease bottlenecks in your network and allow critical applications to take network precedence.

■Fast IP—Allows you to enable and configure Fast IP.

■Administration—Allows you to set DynamicAccess technology control panel access, set VLAN options, enable efficient multicast control, and enable the prioritizing of multicast traffic.

Removing	To remove DynamicAccess technology from your PC, follow the instructions
DynamicAccess	appropriate for your operating system.

Technology

NOTE: For specific instructions on configuring any of the DynamicAccess technology options, click Help on the 3Com DynamicAccess Technology screen or access the 3Com World Wide Web site:

http://www.3com.com/dynamicaccess.

NOTE: Contact your system administrator before you remove DynamicAccess technology from your PC.

Windows 95/98 If the 3Com DynamicAccess Control Panel Administration utility is set to Read Only, you cannot remove the DynamicAccess technology. You must change the access to Read/Write and then remove DynamicAccess technology.

NOTE: Your network connections will break if you select the DA Transport protocols from either the virtual NIC or the physical NIC and click Remove.

Follow this procedure to remove DynamicAccess technology from a PC running

Windows 95 or Windows 98:

1Double-click the Add/Remove Programs icon in the Control Panel.

2Select the DynamicAccess Technology entry and click Remove.

3Restart the PC when prompted.

DynamicAccess technology is removed from the PC.