Multiple NICs 41
13Press Insert.
The Select From the List of Configured Protocols screen appears.
For NetWare 5.0:
a The default To a Network Interface is selected. Press Enter. The Select a Configured Network Interface screen appears.
b Select the board. For example, enter: 3c99x_1, and then press Enter.
14When prompted, enter the network number, and then press Enter.
15In the Frame Type field, press Enter to display a list of frames, choose a frame, and press Enter.
16Press Esc.
You are prompted to save the changes.
17Press Enter to save the changes.
The configured Protocol to Network Interface Bindings screen appears.
18Press Esc to Exit.
The main menu appears.
■NetWare 4.x and earlier: Restart the server.
■NetWare 5.0:
aSelect Reinitialize System.
bPress Enter to reinitialize.
cPress Esc exit from the program.
Multiple NICs | These sections provide procedures for upgrading drivers for multiple installed NICs |
| and installing multiple NICs (new installation) in a NetWare server. |
Upgrading Drivers To upgrade drivers for installed 3Com NICs:
1Uninstall the NIC software for all NICs. For more information Go to: Uninstalling NIC Software.
2Remove all but the first NIC from the server.
3Follow the driver installation procedure for a single NIC. Go to: NetWare 4.10, 4.11, and 5.0.
4Install the next NIC, and then repeat steps 3 and 4 until all NICs are installed.
New Installation If you do not have either NetWare Support Pack 6 or NetWare version 4.2 installed, make sure that all of the NLM files have been copied to the server before you start this procedure.
To install multiple NICs in a Netware 4.0, 4.11, or 5.0 server:
1Install all of the NICs in the server.
2Follow the installation procedure for a single NIC. Go to: NetWare 4.10, 4.11, and 5.0.
