3Com 3CR990 manual Installing, Technology, DynamicAccess, you install the NIC software, Operating

80APPENDIX F: DYNAMICACCESS TECHNOLOGY

The minimum client requirements and recommended Microsoft Service Packs (if any) for DynamicAccess technology are listed in the following table.

Operating		Recommended Microsoft
System	PC Requirements	Service Pack
Windows 2000	486/76 MHz CPU	None required
	16 MB RAM (32 MB recommended)
	5 MB available hard drive space
Windows 95	486/76 MHz CPU	Windows 95 OSR2 or Service
	16 MB RAM (32 MB recommended)	Pack 1
	5 MB available hard drive space
Windows 98	486/76 MHz CPU	Service Pack 1
	16 MB RAM (32 MB recommended)
	5 MB available hard drive space
Windows NT 4.0	Pentium/100 MHz CPU	Service Pack 4
	32 MB RAM
	5 MB available hard drive space
Windows NT 3.51	Pentium/100 MHz CPU	Service Pack 5
	32 MB RAM
	5 MB available hard drive space

Installing	DynamicAccess technology is copied to your hard drive, but not installed, when
DynamicAccess	you install the NIC software.
Technology	To install DynamicAccess technology:
	1 Make sure that the NIC and the NIC software are installed on your PC.
	To confirm the NIC installation
	Go to: Verifying Successful Installation.

CAUTION: If you have a multiprocessor PC that is running Windows NT 4.0, Service Pack 4, download and install the appropriate Microsoft patch before beginning the installation. Failure to install the patch will result in system failure. To download this patch. To download this patch

Go to: http://www.3com.com/dynamicaccess/hotfixes.

2Start Windows.

3Insert the EtherCD in the CD-ROM drive.

4When the EtherCD Welcome screen appears, select NIC Software,

DynamicAccess ®Technology, and then Install DynamicAccess® LAN Agent Version 2.0 now.

DynamicAccess technology is installed. To verify that the installation was successful Go to: Verifying Successful Installation.