3Com 3CR990 Configuring, NOTE You must restart your PC to complete the installation, Installation

Verifying Successful Installation 81

If the EtherCD Welcome screen is not displayed, follow these steps:

1Double-click the DA15.EXE file on your hard drive.

The DA15.EXE file is automatically copied to your hard drive during the NIC driver installation into the following directory:

■Windows 95/98 — C:\WINDOWS\SYSTEM

■Windows NT 4.0 — C:\WINNT\SYSTEM32

■Windows NT 3.51 — C:\WINNT35\SYSTEM32

	The file is expanded and the DynamicAccess technology is installed on your PC.
2	Restart the PC.
	NOTE: You must restart your PC to complete the installation.
	DynamicAccess technology is installed. To verify that the installation
	was successful,
	Go to: Verifying Successful Installation.
Verifying Successful	After DynamicAccess technology is installed, the following changes are visible in
Installation	the Windows Network dialog box:
	■ For each physical NIC installed in the PC, a virtual NIC entry appears in the list
	of network adapters.
	All protocols are re-bound to the virtual NIC. The bindings to the physical NIC
	are still intact.
	■ A 3Com DynamicAccess technology entry appears as a protocol.
	■ A 3Com DynamicAccess technology icon in installed in the Windows
	Control Panel.
Configuring	Contact your system administrator before using DynamicAccess technology
DynamicAccess	at your site.
Technology
	NOTE: DynamicAccess technology configuration instructions are intended for
	network administrators who have experience installing software and using
	management tools for an Ethernet network.
	These instructions are for configuring DynamicAccess technology on a local PC.
	You can obtain the complete configuration instruction set by expanding the
	downloadable file that contains the DynamicAccess technology software.
	Go to: http://www.3com.com/dynamicaccess.

NOTE: You need a Web browser to view the complete configuration instruction set. You do not need to reinstall the software.