3Com 3CR990 manual Go to 3Com DOS Configuration Program, Windows

28CHAPTER 4: WINDOWS DRIVERS

10Select the CD-ROM drives option, clear any other checked options, and click Next.

The Driver Files Search Results screen appears. Windows finds the driver on the CD.

11Click Next.

Files are copied, and then the message “Windows has finished installing the software for this device” appears.

12Click Finish.

The software installation is complete. To verify that the installation was successful Go to: Verifying Successful Installation.

To change configuration settings

Go to: 3Com DOS Configuration Program.

Windows 98	This section describes how to install the network driver and NIC software in a PC
	or server running Windows 98.

Before installing the NIC software:

■Make sure that the NIC is installed in the PC and connected to the network.

■Make sure that you have the Windows 98 installation files. These files may be on a CD or diskettes, or they may have been copied to your hard disk when Windows 98 was installed on your PC.

NOTE: If you encounter problems during the installation, see TROUBLE.TXT (located in the HELP directory on the EtherCD) for troubleshooting tips.

To install the software:

1Turn the PC power on.

Windows detects the NIC. The Add New Hardware Wizard starts.

2Click Next.

The Add New Hardware Wizard screen prompts you to select an option.

3Select the Search for the best driver for your device (Recommended) option, and then click Next.

The Add New Hardware Wizard screen prompts you for the driver location.

4Select the CD-ROM drive option and clear any other check options that are selected.

5Insert the EtherCD in the CD-ROM drive, and then click Next. Windows finds the driver file for the device.

6Click Next. Files are copied.

The Insert Disk screen appears, prompting you for the Windows 98 CD-ROM.