3Com 3CR990 manual Windows, NOTE You must restart your computer to complete the installation

Windows 95 29

7Click OK.

The Copying Files dialog box appears.

8Remove the EtherCD from the CD-ROM drive, insert the Windows 98 CD, enter the path to the CD-ROM drive, and click OK.

The Add New Hardware Wizard displays a message informing you that Windows has finished installing the software.

9Click Finish.

The Systems Settings Change screen appears, prompting you to restart your computer.

10Click Yes to restart your computer.

	NOTE: You must restart your computer to complete the installation.
	To verify that the installation was successful
	Go to: Verifying Successful Installation.
Windows 95	This section describes how to install the network driver and NIC software in a PC
	or server running Windows 95.
	CAUTION: Do not install a 3CR990 NIC while installing Windows 95 OSR2 using
	the “Custom” option. Install Windows 95 OSR2 first, then install the 3CR990 NIC.

Before installing the NIC software:

■Make sure that the NIC is installed in the PC and connected to the network.

■Make sure that you have the Windows 95 installation files. These files may be on a CD or diskettes, or they may have been copied to your hard disk when Windows 95 was installed on your PC.

NOTE: If you encounter problems during the installation, see W95NDIS.TXT and TROUBLE.TXT (located in the HELP directory on the EtherCD) for troubleshooting tips.

To begin the driver installation, turn the PC power on. Windows detects the NIC and depending on the version of Windows 95 that you have installed, either the New Hardware Found screen appears, or the Update Device Driver Wizard starts.

Go to: New Hardware Found.

Go to: Update Device Driver Wizard.