ExpWave 240B Secure Outdoor Ethernet Radio Link
12.3Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this function erases the current configuration before restoring a previous back up configuration; please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your ExpWave since FTP is faster. Please note that you must wait for the system to automatically restart after the file transfer is complete.
WARNING!
Do not interupt the file transfer process as this may PERMANENTLY DAMAGE YOUR ExpWave. When the
Restore Configuration process is complete, the ExpWave will automatically restart.
12.3.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file upload in this chapter.
Menu 24.6
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Press ENTER to Exit:
Figure 12-7 Telnet into Menu 24.6
Step 1. Launch the FTP client on your computer.
Step 2. Enter “open”, followed by a space and the IP address of your ExpWave. Step 3. Press [ENTER] when prompted for a username.
Step 4. Enter your password as requested (the default is “1234”). Step 5. Enter “bin” to set transfer mode to binary.
Step 6. Find the “rom” file (on your computer) that you want to restore to your ExpWave.
Step 7. Use “put” to transfer files from the ExpWave to the computer, for example, “put config.rom
Step 8. Enter “quit” to exit the ftp prompt. The ExpWave will automatically restart after a successful restore process.
12.3.2 Restore Using FTP Session Example
ftp> put config.rom
150Opening data connection for STOR
226File received OK
221Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit
Figure 12-8 Restore Using FTP Session Example
Firmware & Configuration File Maintenance |
|
