ExpWave 240B Secure Outdoor Ethernet Radio Link
Menu 24 - System Maintenance
1.System Status
2.System Information and Console Port Speed
3.Log and Trace
4.Diagnostic
5.Backup Configuration
6.Restore Configuration
7.Firmware Update
8.Command Interpreter Mode
10.Time and Date Setting
11.Remote Management Setup
Figure 13-3 Menu 24 — System Maintenance
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the time and date settings of your ExpWave as shown in the following screen.
Menu 24.10 - System Maintenance - Time and Date Setting
Use Time Server when Bootup= NTP
Time Server Address= tick.stdtime.gov.tw
Current Time: | 00 | : 00 | : 00 | ||
New Time (hh:mm:ss): | 11 | : 23 | : 16 | ||
Current Date: | 2000 | - 01 | - 01 | ||
New Date | 2001 | - 03 | - 01 | ||
Time Zone= GMT+0800 |
|
|
|
|
|
Daylight Saving= No | 01 – 01 |
| |||
Start Date |
| ||||
End Date (mm_dd): | 01 – 01 |
|
|
Press ENTER to Confirm or ESC to Cancel:
Figure
| Table |
|
|
FIELD | DESCRIPTION |
Use Time Server | Enter the time service protocol that your time server sends when you turn on the |
when Bootup | ExpWave. Not all time servers support all protocols, so you may have to check with |
| your ISP/network administrator or use trial and error to find a protocol that works. |
| The main differences between them are the format. |
| Daytime (RFC 867) format is day/month/year/time zone of the server. |
| Time |
| seconds since 1970/1/1 at 0:0:0. |
| NTP |
| None enter the time manually. |
|
|
Time Server | Enter the IP address or domain name of your time server. Check with your |
Address | ISP/network administrator if you are unsure of this information. The default is |
| tick.stdtime.gov.tw |
|
|
Current Time | This field displays an updated time only when you reenter this menu. |
New Time | Enter the new time in hour, minute and second format. |
|
|
Current Date | This field displays an updated date only when you reenter this menu. |
New Date | Enter the new date in year, month and day format. |
|
|
Time Zone | Press [SPACE BAR] and then [ENTER] to set the time difference between your |
| time zone and Greenwich Mean Time (GMT). |
|
|
Daylight Saving | If you use daylight savings time, then choose Yes. |
|
|
Firmware & Configuration File Maintenance |