ExpWave 240B Secure Outdoor Ethernet Radio Link
FIELD | DESCRIPTION |
Len Comp | Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, |
| Less, Greater, Less or Equal or Greater or Equal. |
Source |
|
addr start / end | Source IP address range from start to end. |
|
|
port start / end | Source port number range from start to end; applicable only for TCP/UDP. |
|
|
Destination |
|
addr start / end | Destination IP address range from start to end. |
|
|
port start / end | Destination port number range from start to end; applicable only for TCP/UDP. |
|
|
Action | Specifies whether action should be taken on criteria Matched or Not Matched. |
|
|
Gateway addr | Defines the outgoing gateway address. The gateway must be on the same |
| subnet as the EXPWAVE if it is on the LAN, otherwise, the gateway must be |
| the IP address of a remote node. The default gateway is specified as 0.0.0.0. |
|
|
Type of Service | Set the new TOS value of the outgoing packet. Prioritize incoming network |
| traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max |
| Reliable or Min Cost. |
Precedence | Set the new outgoing packet precedence value. Values are 0 to 7 or No |
| Change. |
Log | Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the |
| system log when a policy is executed. |
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
15.5 Applying an IP Policy
This section shows you where to apply the IP policies after you design them.
15.5.1 Ethernet IP Policies
From Menu 3 – Ethernet Setup, type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup.
You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for example, 2, 4, 7, 9.
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP= Server
Configuration:
Client IP Pool Starting Address= 192.168.1.33
Size of Client IP Pool= 32
Primary DNS Server= 0.0.0.0
Secondary DNS Server= 0.0.0.0
DHCP Server Address= N/A
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version=
IP Policies= 2,4,7, 9
Press ENTER to Confirm or ESC to Cancel: Press Space Bar to Toggle.
Type IP Policy sets, separated by commas.
Figure 15-6 Menu 3.2 — TCP/IP and DHCP Ethernet Setup
IP Policy Routing |
